Dover TWG TULSA WINCH 1500W Servis Kılavuzu - Sayfa 11
Vinçler Dover TWG TULSA WINCH 1500W için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. Dover TWG TULSA WINCH 1500W 19 sayfaları.
Sayfayı Yazdır
1. Evenly remove the four capscrews
pressure will raise the cover as the capscrews are loosened. Remove the cover from the brake
housing.
2. Remove the springs
measure at least 1.200 inches with no force on them.
3. Remove the brake piston
bottom of two spring pockets. Using jam nuts, screw the all-thread pieces in evenly until the
piston is clear of the housing. An alternate way of removing the piston is to use a portable
power unit or shop air to slowly pressurize the brake cavity until the piston is out of the bore.
4. Remove the brake driver/clutch assembly
housing
(Item 21)
.
5. Remove the stator plates
check them for excessive wear, then replace if necessary. Additionally, check the top stator
plate for scoring caused by the removal tools and polish if necessary. Friction discs should
measure no less than 0.055 inches thick and stator plates should measure no less than 0.064
inches thick.
6. If necessary, with a hook wire or pry bar, remove the seal
7. Examine the bushing
8. If the brake housing
housing where the seal
9. Carefully disassemble the brake driver/clutch and note the side in which the markings on the
(Item 34)
clutch
are facing
facing the proper direction in order for the hoist to function properly. Inspect the surface on the
input and brake drivers
or spalling on the drivers then both it and the clutch must be replaced.
10. Re-assemble the driver/clutch assembly, making sure that the clutch is installed properly.
11. Install a new seal
(Item 7-5)
hoist, temporarily install the input sun gear
driver/clutch assembly onto the sun gear spline.
12. Install the stator plates
with a stator and alternating friction discs and stator plates. There is one more stator plate than
friction disc so you will finish with a stator plate.
13. After installation, check the brake stack-up to make sure that the dimensions are within the
tolerance shown in Fig 5. If your measurement is greater than shown, either some friction discs
and stator plates have been left out, or the friction discs are worn beyond acceptable tolerances.
If your measurement is less than shown, too many plates or discs have been inserted or they
are not seated properly.
SERVICING THE BRAKE
(Item 11)
holding the brake cover
(Item 24)
from the piston and check the free height. Each spring should
(Item 10)
by installing two pieces of 3/8"-16NC all-thread in the
(Items 13, 14, 15, 17, 34, and 38)
(Item 19)
and friction discs
(Item 39)
in the brake housing for wear and, if worn, replace it.
(Item 21)
is removed from the hoist, examine the journal on the brake
(Item 7-4)
runs for wear. If severely worn, replace the brake housing.
.
The clutch assembly must be re-assembled with the markings
(Items 13 & 38)
where the clutch
into the brake housing. If the brake housing is removed from the
(Item 19)
and friction discs
11
(Item 20)
(Item 18)
from the brake housing and
(Item 7-5)
from the brake housing.
(Item 34)
runs. If there is any pitting
(Item 38)
into the brake housing and slide the
(Item 18)
into the brake housing starting
in place. Spring
from the brake