Amphony RB1 Kullanım ve Kurulum Kılavuzu - Sayfa 3

Verici Amphony RB1 için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. Amphony RB1 8 sayfaları. 2.4 ghz rangebooster transmitter

User and Installation Guide

Step 1

Preparing the Data cable

The RangeBooster transmitter requires a data connection with the primary

transmitter. This data connection should be established by using a shielded

coaxial cable which is fitted with two RCA connectors.

This cable is not provided with this set and is available from your local video or

satellite equipment dealer.

Suitable cables are video and satellite cables with a cable impedance between

50 and 75 Ohms. Examples of suitable cable types are: RG-174, RG-58 and

RG-6. Cables with low signal attenuation may improve reception. The cable

diameter itself does not influence reception. Unshielded cables may be

susceptible to interference and deteriorate the data connection. Data network

cables may not provide the correct cable impedance and not guarantee

reliable reception.

Since the data connection will transfer high-speed serial audio data, it is

important to select a cable with the correct cable impedance. If a cable with a

cable impedance outside of the range of 50 to 75 Ohms is used, it may be

necessary to use appropriate adapters that will convert the cable impedance

to 50 to 75 Ohms at each end of the cable in order to avoid a cable impedance

mismatch at the transmitter side.

RCA connector

Step 2

Locating the RangeBooster transmitter

The location of the RangeBooster transmitter should be chosen such that:

the number of walls and obstacles between the RangeBooster transmitter

and the headphones / receiver is minimized anywhere in the desired

coverage area to improve reception;

the cable length of the data cable will be as short as possible (preferably

less than 30 to 50 ft) to minimize data signal degradation; and

there is sufficient RF signal attenuation between the primary transmitter

and the RangeBooster transmitter (no line of sight) to minimize RF signal

competition between both transmitters.

Elevation as well as the presence of reflecting walls will influence the coverage

area of the RangeBooster transmitter. It is suggested to experiment in order to

find the best location for the RangeBooster transmitter.

Data cable

50 to 75 Ohms shielded coaxial cable

RCA connector

R R

Page 2