Amphony 1550 Kullanım ve Kurulum Kılavuzu - Sayfa 9

Amplifikatör Amphony 1550 için çevrimiçi göz atın veya pdf Kullanım ve Kurulum Kılavuzu indirin. Amphony 1550 13 sayfaları. 5.8 ghz digital wireless audio transmitter/amplifier
Ayrıca Amphony 1550 için: Sıkça Sorulan Sorular (5 sayfalar), Teknik Özellikler (2 sayfalar), Özellik Karşılaştırması (1 sayfalar), Teknik Özellikler (4 sayfalar), Teknik Özellikler (4 sayfalar), Kullanım ve Kurulum Kılavuzu (12 sayfalar), Ürün Bilgileri (4 sayfalar), Kullanım ve Kurulum Kılavuzu (6 sayfalar)

Sayfayı Yazdır
Amphony 1550 Kullanım ve Kurulum Kılavuzu
User and Installation Guide

Troubleshooting

Proble m
The transmit light
do es not go on after
DC power is applied
to the transmitter
The transmit light
go es out after a few
seco nds and does
no t li ght again
No a udio at
amplifie r
Aud io is distorted
Spe aker audio level
is too lo w
Page 8
Possible Cause
Faulty AC adapter
or faulty power outlet
No audio present at
audio input
Tran smitter hung up
Faulty AC adapter
or faulty power outlet
Tran smitter volume
control set too low
Amplifier volume
control set too low
Strong interference
Tran smitter volume
control set too high
Amplifier volume
control set too high
Strong interference
Tran smitter volume
control set too low
Amplifier volume
control set too low
Audio signal too
weak
Solution
Check the power outlet and
the AC adapter; if possible,
check for correct voltage of
the AC adapter.
Check the audio connection
to the transmitter and ensure
that there is audio present.
Disconnect and then
reconnect DC power.
See under "Faulty AC adapter
or faulty power outlet" above.
Adjust the transmitter volume
control.
Adjust the amplifier volume
control.
See under "Strong
Interference" on next page.
Adjust the transmitter volume
control until clipping stops.
Adjust the amplifier volume
control until clipping stops.
See under "Strong
Interference" on next page.
Adjust the transmitter volume
control to achieve desired
audio level.
Adjust the amplifier volume
control to achieve desired
audio level.
Increase the output level of
the audio source (connect
transmitter to an adjustable
output by using an adapter if
necessary).
R