User and Installation Guide
Troubleshooting
Problem
Possible Cause
The transmit light
Faulty AC adapter
does not go on after
or faulty power outlet
DC power is applied
to the transmitter
The transmit light
No audio present at
goes out after a few
audio input
seconds and does
not light again
Transmitter hung up
No audio at
Faulty AC adapter
amplifier
or faulty power outlet
Transmitter volume
control set too low
Amplifier volume
control set too low
Strong interference
Audio is distorted
Transmitter volume
control set too high
Amplifier volume
control set too high
Strong interference
Speaker audio level
Transmitter volume
is too low
control set too low
Amplifier volume
control set too low
Audio signal too
weak
Page 7
R R
Solution
Check the power outlet and
the AC adapter; if possible,
check for correct voltage of
the AC adapter.
Check the audio connection
to the transmitter and ensure
that there is audio present.
Disconnect and then
reconnect DC power.
See under "Faulty AC adapter
or faulty power outlet" above.
Adjust the transmitter volume
control.
Adjust the amplifier volume
control.
See under "Strong
Interference" on next page.
Adjust the transmitter volume
control until clipping stops.
Adjust the amplifier volume
control until clipping stops.
See under "Strong
Interference" on next page.
Adjust the transmitter volume
control to achieve desired
audio level.
Adjust the amplifier volume
control to achieve desired
audio level.
Increase the output level of
the audio source (connect
transmitter to an adjustable
output by using an adapter if
necessary).
User and Installation Guide
Placing the transmitter and amplifiers
For best reception, we recommend that each amplifier be placed within the line
of sight from the transmitter. If possible, each amplifier should be placed right
side up with its front toward the transmitter.
The transmitter should be placed at an elevation such that there are no
obstacles between the transmitter and amplifiers (line of sight) in an area where
there will be the least amount of traffic. We suggest that you place the
transmitter on top of your audio source. Example 1 below shows the optimum
placement of the transmitter and an amplifier. If no line of sight is possible, place
the transmitter and amplifiers such that there is the minimum possible number of
walls and obstacles between the transmitter and each amplifier.
The amplifiers can also be placed as shown in example 2. In this case, no line-
of-sight connection exists and the operating range is reduced.
You can mount the amplifiers vertically by using the 2 screw openings at the
bottom of each amplifier. If the amplifiers are mounted vertically, the operating
range is reduced compared to mounting the amplifiers right side up.
Each amplifier incorporates a directional antenna which prefers signals
transmitted toward the front of the amplifier. Therefore, the front of the amplifiers
should always be facing toward the direction of the strongest transmitter signal.
By properly orienting each amplifier, interference from other signal sources can
be minimized.
We suggest that you experiment with placement in order to find the best location
for the transmitter and amplifiers.
Note: This product will not work properly from within an enclosed metal cabinet.
Transmitter
Amplifier
line of sight
Speaker
Example 1: Amplifier placed
on top of a speaker
R R
Transmitter
indirect connection
Amplifier
(reflected signal)
Speaker
Example 2: Amplifier mounted
vertically behind a speaker
Page 4
Sayfayı Yazdır