Follett 400 Series Kurulum ve Servis Kılavuzu - Sayfa 13

Buz Yapıcı Follett 400 Series için çevrimiçi göz atın veya pdf Kurulum ve Servis Kılavuzu indirin. Follett 400 Series 20 sayfaları. Icemaker and top kit for remcor/cornelius countertop ice and beverage dispensers

Sayfayı Yazdır

23. Connect the ice transport tube(s) to the dispenser:

a) Drill 3/16" (5mm) holes through both sides of the tube

1/2" (13mm) from the tube end.

b) Collapse tube and insert through gasketed hole (Fig. 14.1).

c) Match tube holes to bracket tabs.

24. Route bin thermostat capillary tube from the 4" x 4"

(102mm x 102mm) junction box into bin alongside the ice

transport tube. Secure capillary tube into bracket (Fig. 8).

25. Reinstall the dispenser cover with supplied screws (Fig. 14).

26. Install telescoping chase.

a) Mount lower chase section to chase bracket on counter

with supplied screws (Fig. 15.1).

b) Position upper chase section over lower chase section.

Align top of upper section to top of stainless dispenser top

and secure with screw (Fig. 15.2).

c) Drill pilot holes on both sides of chase and secure with

supplied screws (Fig. 15.3).

27. Turn icemaker power and water on.

28. After icemaker has made ice for approximately 15 minutes

complete the following start-up checks:

a) Dispense ice.

b) Hold ice on bin thermostat and make sure

icemaker shuts off.

c) Remove ice from bin thermostat and make sure

icemaker restarts.

Note: Icemaker has a 20 minute restart delay.

Fig. 14

Fig. 15