Follett HCC1010WBS Manuel - Sayfa 7

Buz Yapıcı Follett HCC1010WBS için çevrimiçi göz atın veya pdf Manuel indirin. Follett HCC1010WBS 8 sayfaları. Self-contained chewblet ice machine
Ayrıca Follett HCC1010WBS için: Kurulum Talimatları Kılavuzu (17 sayfalar), Hızlı Başlangıç Kılavuzu (8 sayfalar)

Sayfayı Yazdır

4 – Horizon Elite ice machine mounting accessories

Optional wall mount bracket

30.50"

(77.7 cm)

5 – Horizon Elite drain - specifier guidelines

Flush drain plumbing – For regular machine drainage

Chassis drain plumbing – To assist with condensate in high humidity areas

Self-contained 1010, 1410 series ice machine

Optional machine stand

22.00"

(55.9 cm)

A - 25.2" (64.0 cm)

25.50"

B - 28.7" (72.9 cm)

(64.8 cm)

➊

Minimum 8"

radius

2 ft x 1" OD

silicone tubing

3/4" barb x 3/4" FPT

➋

3/4" MPT x 1" slip

➌

1" Stand pipe/drain

6.88"

(17.50 cm)

13.00"

(33.0 cm)

21.00"

(53.3 cm)

Important specifier notes: Where code

allows, follow recommendation below.

1. Connect the silicone tubing to the ice machine 3/4"

2. Assemble the 3/4" barb x 3/4" FPT to the 3/4" MPT x

3. Connect the 1" slip fitting to the 1" stand pipe/drain

Important specifier notes: Where code

allows, follow recommendation below.

1. Plug must be removed from John Guest fitting.

2. Route 3/8" drain tubing through knockout in back of

3. Drain must slope 1/4" inch per foot ( 6 mm per 30.4 cm).

Important specifier notes

1. For secure wall mounting, specify optional

wall mount bracket.

2. Wall and fasteners must support the weight

of the ice machine, bracket, supply water and

ice. Use of a backing board may be required

with hollow wall construction.

3. Machine stand mounting adds 6.88"

(17.48 cm) to height of ice machine.

4. No dips in tube routing allowed.

5. Ice transport tube needs minimum 1/4"

per foot (2 cm per meter) pitch toward ice

machine and should be secured to prevent

dips and traps from forming.

➊

drain barb

1" slip. Connect the other end of the silicone tubing to

➋

the 3/4" barb

Note: Minimum 8" radius on silicone drain line. Drain line

from the ice machine must have at least 1/4" per foot

pitch (6.4 mm/0.3 m).

Note: Stand pipe/drain provided by others. All other

components provided with ice machine.

docking station and insert fully into John Guest fitting

connection at the rear of the machine chassis. Route

other end of 3/8" drain tubing to drain.

➌

Form# 7030