Follett Horizon Elite HCD1010N Kullanıcı Kılavuzu - Sayfa 3
Buz Yapıcı Follett Horizon Elite HCD1010N için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Follett Horizon Elite HCD1010N 17 sayfaları. Remote condensing
Sayfayı Yazdır
Specifications
Electrical
Separate circuit and equipment ground required.
Evaporator unit
Standard electrical: 115/60/1
Maximum fuse: 15A
Amperage: 5A
Condensing unit
Electrical
Max Circuit HVACR breaker size
Min Circuit Ampacity
Evaporator plumbing
§ 3/8" OD push-in water inlet (connection inside machine) - 3/8" OD tubing required.
§ Water shut-off recommended within 10 feet (3 m).
§ Follett recommends installation of Follett water filter system (part# 00130286) in ice machine inlet water line.
Flush drain plumbing
§ 3/4" MPT flush drain connection at the rear of the machine.
§ Drain must slope 1/4" inch per foot (6 mm per 30.4 cm).
§ Drain line should not be shared with any other piece of equipment.
§ Drain line cannot be reduced to a size smaller than 1 inch.
§ Drain should be piped without a vent.
2 ft. x 1" OD
silicone tubing
(6,4 mm per 0,3 m)
Horizon Elite 1010/1410 Ice Machines (Remote Condensing)
1010 Single-Phase
208-230V, 60Hz
15A
10.7A
3/4" barb x 3/4" FPT
3/4" MPT x 1" slip
1/4" per foot
1'
1010 3-Phase
1410 Single-Phase
208-230V, 60Hz
15A
9.9A
1" PVC Drain
1410 3-Phase
208-230V, 60Hz
208-230V, 60Hz
30A
19.3A
Minimum 8"
radius
2 ft. x 1" OD
silicone tubing
3/4" barb x 3/4" FPT
3/4" MPT x 1" slip
1" Stand pipe/Drain
25A
14.2A
3