AmpliVox SS3230RTA Montaj Talimatları Kılavuzu - Sayfa 6

Kürsü Sistemi AmpliVox SS3230RTA için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. AmpliVox SS3230RTA 12 sayfaları. Ready to assemble multimedia lectern

Sayfayı Yazdır

AmpliVox SS / SW3230 RTA ASSEMBLY INSTRUCTIONS

DRAWER

• Locate Panel (2) and item (N) Drawer Slides.

Each slide is made up of two components. One

component goes on the drawer the other on the

side panels. Locate the two slide components

that have a hinged bracket attached to the front

of the slide.

• Panel (2) has one side that has pilot holes and

the other side is smooth. Place the smooth panel

side down on a flat surface. Note that three of the edges are painted black and one

side is plain. The plain side is the back of the drawer.

•

Take a slide component that has the hinged bracket

and align it with the pilot holes. The hinged bracket

goes on the opposite side of the plain edge. Screw

into panel using item (I) screw. Do the same for

other side. Use three screws for each slide

component.

• Locate Panel (9). Take Panel (2) and turn over.

Align the holes in the hinged bracket with the pilot holes on Panel (9). Using item (I)

screw, start all four screws. Once you have all four screw started, then go back and

tighten.

• Set panel aside.

SIDE PANEL WITH SMALL DOOR

• Locate Panel (6), Panel (3), items (B) (F) (E)

(N). Lay Panel (6) on flat surface with the side

that has all the holes facing up.

• Take Panel (3) and place inside with holes facing

up and positioned with the door lock hole as

shown.

• Take item (B) which is a flat looking hinge, and place

into the large circular cutout on Panel (3). Screw into

place using item (I) screw, four places on each hinge.

• Take item (F), key lock, and drop into the hole on Panel (3). Screw into place with two

item (G) screws.

• Take item (E) dowel rods and insert into hole, three places, and tap down.

Black Edge