AmpliVox B8001-96-01 Kullanıcı Kılavuzu - Sayfa 7

Hoparlör Sistemi AmpliVox B8001-96-01 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AmpliVox B8001-96-01 12 sayfaları. Titan wireless battery powered pa system

WIRELESS HANDHELD MICROPHONE

R
Frequency Set Button (R)
Channel Display / Battery Meter (S)
Select Buttons - Manual Channel Selection (T)
Power Indicator (U)
Power Switch (V)
HANDHELD MICROPHONE BATTERY INSTALLATION
• Press latch on ANTENNA CAP (W) and slide off. Must re-
move first to get BATTERY COVER (Y) off.
• Press latch on BATTERY COVER (Y) and slide off.
• Insert 2 AA 1.5V Alkaline Batteries. Observe proper
polarity when inserting. Insert (-) negative end of battery first
into opening. Install the second battery.
• Slide BATTERY COVER back on until it locks into place.
• Slide ANTENNA CAP back on until it locks into place. You
have been supplied three color caps besides the black cap
to choose from. Allows you to use a different color for identi-
fication when you have more then one handheld micro-
phone.
WIRELESS MICROPHONE CHANNEL SETUP
• Press POWER SWITCH (V) and hold 2-3 seconds to power
on the microphone. The POWER INDICATOR (U) will light
and CHANNEL DISPLAY (S) will show ON. To automatically
sync to the same channel that appears on the wireless panel
receiver press SET Button (R) and then press SYNC button
on Receiver Panel (D). Both displays will FLASH and sync to
the same channel.
• To manually select a CHANNEL first press and hold the SET
BUTTON (R) until the channel number begins to flash. Then
using the UP / DOWN BUTTONS (T) select channel that ap-
pears on the Receiver Panel (A). Press SET BUTTON (R) to
lock in channel number. Channel numbers must match for the
wireless microphone to work. To see the frequency that the
channel is on you can press and hold either the UP or Down
button.
S
T U
V
X
W
Latch
Antenna Cap (W)
Sensitivity / Mute Switch (X)
Battery Cover (Y)
OPERATION
• Check BATTERY METER in the CHANNEL DIS-
PLAY (S). Strong batteries are needed for good
transmission to receiver. When battery meter shows
only one bar you should replace batteries. If no bars
are showing, indicating that the batteries are ex-
hausted, display will flash three times and then auto-
matically turn off.
A fresh set of quality batteries will last approximately
8 hours.
• SENSITIVITY / MUTE SWITCH (X): If you are a soft
spoken person then set the switch to the HI position.
If you are a loud speaking person then set the switch
to the LOW position. Adjust to prevent distortion
while speaking.
MUTE : If you temporarily want to silent the micro-
phone without turning it off, slide switch all the way
down to MUTE microphone. When ready to use mi-
crophone again, slide switch to HI / LOW position
and begin to speak.
• When done speaking, press and hold POWER
SWITCH (V) for 2 seconds until you see the word
OFF in the CHANNEL DISPLAY (S). The micro-
phone is now OFF. POWER INDICATOR (U) will go
off when power switch is released.
7
Latch
Y