AmpliVox SW800 Kullanıcı Kılavuzu - Sayfa 5

Hoparlör Sistemi AmpliVox SW800 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AmpliVox SW800 10 sayfaları. Battery powered pa system
Ayrıca AmpliVox SW800 için: Kullanıcı Kılavuzu (8 sayfalar), Kullanıcı Kılavuzu (8 sayfalar), Kullanıcı Kılavuzu (10 sayfalar), Kullanıcı Kılavuzu (12 sayfalar)

Sayfayı Yazdır

AUDIO FUNCTIONS

3 MASTER AUDIO CONTROLS:

VOLUME:

This is the master volume control for the system.

BASS:

This control cuts or boosts the bass level.

TREBLE:

This control cuts or boosts the treble level.

WIRELESS UHF RECEIVER:

be used to set level on the wireless microphone. Set WIRELESS

LEVEL and MASTER VOLUME level at desired setting.

CD / MEDIA PLAYER LEVEL:

player. Set CD LEVEL and MASTER VOLUME level at desired

setting.

ACCESSORY VOLUME CONTROL:

THIS MODEL

LINE IN INPUTS:

Add pre-recorded music to your presenta-

tions from an external source such as a computer or MP3 player

can be used by connecting to the 1/4" jack or the L/R RCA jacks.

A separate LINE IN VOLUME CONTROL is also provided for

controlling sound level of the external source.

16 CHANNEL UHF WIRELESS

IRELESS

ECEIVER

ANEL

Channel Display (A)

Select Buttons - Manual Channel Selection (B)

On/Off/Volume Control (C)

On Indicator Light (D)

AF - Audio Frequency Indicator (E)

RF - Radio Frequency Indicator (F)

/ T

ECEIVER

RANSMITTER

The receiver has its own POWER / VOLUME Control (C). Turn

Power On. A Frequency Channel will appear in the Channel

Display (A). Press Select Buttons (B) to select a channel. Chan-

nel number must match channel number on wireless transmitter

or wireless microphone.

The wireless transmitter bodypack is operated by 2 - "AA" 1.5

Volt Rechargeable batteries. Slide off battery cover (G) and

install batteries as shown. Make certain the battery is fully

seated in its compartment so the cover slides in place easily.

Battery life with rechargeable batteries is approximately 8 hours

of operating time.

Select a channel (1-16) on front panel (H) using the knob

to select channel number. Channel selected should match

channel on receiver. When transmitter and receiver are set to

correct channel, the RF indicator (F) will glow red when

transmitter is turned on.

Plug the Lapel microphone into the Mic Input Jack (I). The

microphone can be clipped to a necktie or other clothing,

using the supplied clip. The lapel mic should be placed under

the chin, as close to the center of the body as possible

Slide the power ON/OFF switch (J) to the ON position (the

LED indicator light will illuminate green). Recharge batteries

when this LED turns red.

IMPORTANT: BODYPACK GOES INTO STORAGE COMPART-

MENT, ANTENNA FIRST, WITH ANTENNA POSITIONED ON

A separate volume control can

Use to change output level of

NOT USED WITH

ETUP:

LEFT SIDE

ECHO CONTROL:

This is a sound effect feature that makes

the audio signal sound as though it's in a large area, such as a

large cathedral or a cave, by repeating the sounds that come

into the SW800 through the microphones or any of the accesso-

ries. The listener will hear the original sound, plus the repeated

sounds created by this feature.

MICROPHONE INPUTS:

combination XLR / ¼" jack (this jack will accept either type mi-

crophone).

"AA" BATTERY CHARGER:

sets of batteries that are used in the wireless handheld micro-

phone and the wireless microphone body pack transmitter.

ONLY USE RECHARGEABLE BATTERIES. CAN NOT BE

USED FOR ALKALINE BATTERIES. ALKALINE BATTERIES

MAY EXPLODE AND CAUSE A FIRE.

Red LED means charging. Green LED means fully charged.

LINE OUT JACKS:

The SW800 panel has 2—¼" phone

jacks labeled EXT SPK / MIX OUT

Wireless Transmitter - Bodypack

Battery Cover

Removed

Top Panel

One ¼" microphone jack and one

Pull out drawer recharges both

Channel Selector