AmpliVox S-250 Montaj Talimatları
İç Mekan Mobilyaları AmpliVox S-250 için çevrimiçi göz atın veya pdf Montaj Talimatları indirin. AmpliVox S-250 2 sayfaları. Quickfit-expando-6 connectors for w/s-250 tabletop lectern assembly
Sayfayı YazdırPacking List:
Reading table top
Bottom panel
2 Side pa n e l s , l e ft a n d r i g h t
Front/speaker panel
Black speaker grille(S-250)
Hand-held mic (S-250)
Mic cable (S-250)
Gooseneck w/mic holder (S-250)
Amplifier (S-250)
Reading
Ta b l e Top Panel
Speaker/
Front
Panel
1. Unpack all the pieces. Be sure to
save the packing and the box in case
you need to return the lectern for any
reason. Check that you have all the
pieces and that they are not damaged.
2. Insert the dowel pins. W i t h y o u r
F:\docs\productinstructions\r-
Featuring Quickfit-Expando-6 Connectors
The Tabletop Lectern is designed
for easy assembly. If you have any
questions about assembling or using
your new sound system, or if you want
more information about accessories,
c a l l
s e r v i c e l i n e .
1-800-267-5486
Hardware:
12 Quickfit-Expando-6 Connectors
p r e - i n s ta l l e d
12 Push-in Quickfit-6 Expanding dowels
Tools Needed:
P h i l l i ps Screwdriver - for 1 / 2 t u r n o f p r e -
inserted Quickfit-Expando-6 Connectors
Quickfit-6 Expanding Dowel Pin
L e ft S i d e
thumb(or use phillips screwdriver to
ease insertion), push the dowel pins
into the holes in the 2 sides and the top.
Make sure the plastic collar is flush with
the wood surface.
Easy Step-By-Step Instructions
for W/S-250 Tabletop Lectern Assembly
AmpliVo x s
customer
Bottom
Right Side
The lectern is carefully packed
to minimize shipping damage. If your
unit was damaged in shipping call our
t o l l - f r e e c u s t o m e r s e r v i c e l i n e o r v i s i t
our web site at http://www.ampli.com
The Ti t u s f i t t i n g s s u p-
kit have been specially
for ease of
3. Inspect the Pre-installed Quickfit
Expando-6 Connectors. Check the To p ,
Speaker/Front, Left and Right Side
Panels to insure that the flat edge on the
connector is facing the outer edge of the
board. Use a phillips screwdriver to rota t e
them, if needed.
Untightened
(unlocked)
Edge of board
How the Quickfit-Expando-6 Connectors
work.
Do not over tighten the connectors.
They will break if turned too far. Turn only
1 / 2 t u r n clockwise t o l o c k . The steel
Quickfit-6 expanding dowels and the
Quickfit-Expando-6-Connectors
together for easy assembly.
Tu r n counterclockwise to unlock
Tightened
To untighten
(locked)
Edge of board
To t i g h t e n
( t o l o c k )
lock
(to unlock)