AmpliVox S207A Kullanım Talimatları - Sayfa 2

Amplifikatör AmpliVox S207A için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. AmpliVox S207A 2 sayfaları. Wireless portable public address waistband amplifier

Sayfayı Yazdır
NOTE: Only original Belt Blaster Pro NiMH batteries are to be charged in the unit. Attempting to charge disposable or not approved batteries may
cause leakage and damage to the unit and void the product warranty.
BATTERY REPLACEMENT
All 6 batteries MUST be replaced at the same time. Mixing old and new batteries can lead to battery failure.
CHARGING BATTERIES FOR FIRST USE
Your new Belt Blaster Pro is shipped with 6 Nickel Metal Hydride rechargeable batteries installed. They must receive a deep charge (24 hours)
before being used regularly. You may test the unit short term when you first get it. But charge the batteries fully to maximize performance.
1. Insert battery charger mini plug (AC adapter) into the charging port located on the bottom of the amplifier.
2. Plug the adapter into a working power outlet.
3. Charge the Belt Blaster Pro for 24 hours for the first charge. After this only an 8-14 hour charge is necessary.
OPERATING INSTRUCTIONS
The unit is usually worn on the front of the waist much like a "waist
pack" that would hold your wallet. The woven nylon waist band is
adjustable to 44 inches. Larger waist dimensions can be accommo-
dated by using the 12 inch extension. Remember to wear the Belt
Blaster Pro so the speaker grill faces out or down to avoid feedback.
1. With the amplifier turned OFF, insert the 3.5mm microphone jack
into the screw on jack on top of the amplifier.
2. Put the amplifier on your waist, adjust the attached belt to fit,
then clip the buckle. Please take note of the path of the nylon
belt through the clips. In the event that the belt is disassembled,
it is imperative that the belt be correctly reinstalled.
3. Turn the amplifier ON by turning the volume to the 11 o'clock
position while speaking at a consistent volume level
4. When you perceive your voice is loud enough, reduce the volume
slightly. This is done because you are standing behind the
speaker and your voice is considerably louder than you perceive.
NOTE:
1. The transformer may be used to recharge batteries, and to power
the amplifier simultaneously.
2.
Caution!
The transformer should NEVER be used to power any
amplifier with regular non-rechargeable batteries inside it. The
non-rechargeable batteries should be taken out before the
transformer is connected. Otherwise serious damage may be
caused to the batteries.
PHONE (800) 267-5486
FAX: (800) 267-5489
ON/OFF
VOLUME
WEB: WWW.AMPLI.COM
BATTERY
* SCREW-ON
INDICATOR
MICROPHONE
JACK
*The screw-on jack prohibits the cable from
inadvertently pulling out when moving around.
CHARGER JACK
AND CHARGE
INDICATOR