AmpliVox SB601R Hızlı Başlangıç Kılavuzu

Amplifikatör AmpliVox SB601R için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. AmpliVox SB601R 2 sayfaları. Mity-meg 20 watt megaphone

Sayfayı Yazdır

AmpliVox SB601R Hızlı Başlangıç Kılavuzu

Thank you for purchasing

AmpliVox SB601R MITY- MEG 20 Watt MEGAPHONE

We encourage you to visit our website www.ampli.com to register

your product for its warranty coverage, sign up to receive our

newsletter, download our catalog, and learn more about the com-

plete line of AmpliVox audio visual products, including portable PA

systems, and lecterns.

OPERATING INSTRUCTIONS

First

Battery:

charge battery before using. Unfold the plug on the S1402 battery



pack (A) and plug into AC outlet (110V-240V). Battery will reach full charge in

approximately 2 hours. LED light on top of battery pack (B) will change from

red when charging, to green when fully charged. There is no memory effect

with this battery pack so you can recharge whenever you feel like it!

Operating Capacity and Standby Time: A fully charged battery will provide 8



hours of typical operation, defined as speaking 35% of the time at mid volume,

and over one year of standby / idle time.

Cycle Life: Lithium-ion battery pack can be expected to provide 80% of its rat-



ed capacity after 300 charge / discharge cycles and 60% after 500 cycles. Stor-

ing, transporting or using the battery pack at temperatures exceeding

115° F / 45° C or -4° F / - 20° C will substantially reduce the cycle life of the

battery pack.

Locate battery compartment latch on top of megaphone

Install Battery:



(C). Open megaphone and insert battery into compartment (D) with led pointing

up. Plug cord into the two pin connector located to the lower left of battery open-

ing inside (E). Close megaphone. Do not pinch cord when closing.



Battery Status: The megaphone has 3 LED's LOW, MID, HIGH, (F) that will

tell you the current strength of the battery. Note: A drained battery will not give

sufficient sound volume. Recharge the battery when LOW LED lights when trig-

ger is squeezed.



Talk: Make sure that the switch (G) is in the Off / Talk position. Place mouth

about one inch from microphone (H), squeeze trigger (I) and speak. To increase

volume, rotate volume control (J) left to right.

When you have a freshly charged battery you may get "feedback" when talking.

To eliminate feedback you need to turn down the gain. Locate the gain control

(K) in the battery compartment. Turn until you do not hear any feedback. Less

gain, turn counter clockwise. More gain, turn clockwise.

Siren: To activate Siren, move switch (G) to the right. Siren will be heard. There



is no control of the volume.



Whistle: To activate Whistle, move switch (G) to the left. Whistle will be heard.

There is no control of the volume.

Property Label: Located on the bottom of the bell. Use marking pen to write



ownership name on megaphone.

IF YOU HAVE ANY QUESTIONS OR PROBLEMS PLEASE CALL

OUR CUSTOMER SERVICE DEPARTMENT AT 1-800-267-5486