Comco ESD Control ProCenter CTR101-1 Kılavuz Eki - Sayfa 2

Masaüstü Comco ESD Control ProCenter CTR101-1 için çevrimiçi göz atın veya pdf Kılavuz Eki indirin. Comco ESD Control ProCenter CTR101-1 6 sayfaları.

ProCenter CTR101-1

MicroBlaster Abrasive Hose and Vent Hose Connections

ESD Control ProCenters are equipped with ESD Control handpieces, which are installed in the ProCenter.

MicroBlasters prepared for use with the ESD Control ProCenter are shipped without the standard handpieces

and have their abrasive and vent hoses cut to proper length for installation. Refer to the following drawings

for correct hose connections.

Note: When routing abrasive or vent hoses, avoid sharp bends to prevent excessive hose wear.

If you are connecting a MicroBlaster that has the standard handpiece(s) installed, remove the handpiece(s)

and trim the hose lengths to form a 4-5" diameter loop exiting the fittings on the back of the blaster. Allow a

smooth path to the connection points on the ProCenter.

MS-CTR101-1

Page 2 of 2

Manual Supplement

Single Tank

MicroBlaster

Dual Tank

MicroBlaster

Issue Date: June 2003