Amprobe 2730785 Kullanıcı Kılavuzu - Sayfa 7

Ölçüm Cihazları Amprobe 2730785 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Amprobe 2730785 17 sayfaları. Professional 1000a clamp meters

Sayfayı Yazdır

• Keep your hands/fingers behind the hand/finger barriers (of the meter and the test leads)

that indicate the limits of safe access of the hand-held part during measurement.

• Inspect test leads, connectors, and probes for damaged insulation or exposed metal before

using the instrument. If any defects are found, replace them immediately.

• This Clamp-on meter is designed to apply around or remove from un-insulated hazardous

live conductors. Individual protective equipment must be used if hazardous live parts of

the installation could be accessible.

• Exercise extreme caution when: measuring voltage >20 V // current >10 mA // AC power

line with inductive loads // AC power line during electrical storms // current, when the fuse

blows in a circuit with open circuit voltage >1000 V // servicing CRT equipment.

• Remove test leads before opening the case to change the battery.

• Disconnect circuit power and discharge all high-voltage capacitors before testing

resistance, continuity, diodes, or capacitance.

• To avoid false readings, which could lead to possible electric shock or personal injury,

replace the batteries as soon as the low battery indicator (�) appears.

• To avoid electric shock hazard, do not use the HOLD � mode to determine if a circuit is

live. Unstable readings will not be captured and displayed.

• Only use the accompanied test leads, or replace the same rating or better UL Listed Probe

Assembly.

�

CAUTION

for non-invasive ACA current measurements, clamp the jaws around only one single

conductor of a circuit for load current measurement. More than 1 conductor will cause false

readings.

UNPACkINg AND CONTENTS

Your shipping carton should include

ACD-6 PRO or ACD-6 TRMS-PRO

Test lead set

3V coin battery IEC-CR2032 (installed)

Users Manual

Carrying Case

If any of the items are damaged or missing, immediately return the complete package to the

place of purchase for an exchange.

INTRODUCTION

The ACD-6 PRO or ACD-6 TRMS-PRO Clamp-On meters are autoranging 1000 ACA / 600 V

clamp meter. The features include AC / DC voltage, AC current, Resistance, Continuity, Diode

and Continuity tests.

OPERATION

Manual or Auto-ranging

Press the RANGE button for more than 1 second to enable/disable auto-ranging. Press the

button momentarily again to step through the Ranges. The LCD symbol

is turned off.