Amprobe CO2-200 Kullanıcı Kılavuzu - Sayfa 12

Ölçüm Cihazları Amprobe CO2-200 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Amprobe CO2-200 18 sayfaları. Wall mounted co2 meter

When entering setup mode, P1.0 and "AL" are displayed

on the LCD (Fig. 4). Press "SET" again to go into P1.1 for

setting CO2 upper limit. The current set value will be

blinking on LCD (Fig.5). Press "p/DP/WB" to increase the

value or "MNX/AVG/q"to decrease. Each press tunes

100 ppm and the alarm range is from 100 to 9900ppm.

When the preferred value is set, press "SET" to go into

P1.2 for lower limit setting. After both settings are done,

press "SET" to save or "CAL/ESC" without saving and

return to P1.0.

P3.0: Temperature scale

Press "p/DP/WB" in P1.0 to access P3.0 for setting up

temperature scale. Press "SET" and it goes into P3.1 with

blinking °C or °F current set on the lower left display.

To switch °C or °F, press "p/DP/WB "or "MNX/AVG/q".

Then press "SET" to save the setting or "CAL/ESC"

without saving and return to P3.0.

P4.0: ABC selection

Press "p/DP/WB" in P3.0 or "MNX/AVG/q" in P1.0 to

access P4.0 for selecting ABC function. Press "SET" and it

goes into P4.1 with blinking "dis" default (Fig. 6) on the

lower left display. To enable the ABC function, press "p/

DP/WB" or "MNX/AVG/q" and "En" blinks for choice.

After the preferred selection is done, press "SET" to save

the setting or "CAL/ESC" without saving and return to

P4.0.

Calibration Mode

ABC (Automatic Baseline Calibration)

ABC is to implement baseline calibration to

eliminate the zero drift of the NDIR sensor. It

calibrates the meter at the minimum CO2 reading

detected during 7 days continuous monitoring

(power on). It's not suitable to implement ABC in

close area with higher CO2 level all the time. The

ABC default is off. To enable the function, please

refer to SETUP P4.0.