Amprobe MT-10 Kullanıcı Kılavuzu - Sayfa 9

Ölçüm Cihazları Amprobe MT-10 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Amprobe MT-10 13 sayfaları. Moisture meter

INTRODUCTION

Moisture meters MT-10 can be used to measure the

amount of water in the wood or building material so

that the woodworker can determine if it is suitable for

the intended purpose. Building inspectors, carpenters,

hobbyists, and other woodworkers often are required

to have moisture meters. Wood flooring installers, for

example, have to verify that the moisture of the wood

matches the relative humidity in the air of the building.

If this step is skipped, a vast array of problems may

present itself: cracking, cupping, crowning, buckling,

sunken joints, and cracked finishes.

1. Press the POWER ON/OFF button once to turn on

the instrument

2. Selecting desired Measurement Mode

a) After the instrument has been turned on, press

and hold down the button for about 3 seconds

to enter Setting Mode (reading disappears,

symbol starts flickering on the display).

b) While symbol is flickering on the display, press

the button until the meter is in the desired

measurement mode and the corresponding

symbol flickers on the display.

The four modes are as follows:

Wood moisture measurement mode

(" "flickers), material moisture measurement

mode (" "flickers), Celsius temperature

measurement mode ("°C"flickers), Fahrenheit

temperature measurement mode ("°F"flickers).

c) After the desired measurement mode is

selected, don't operate the instrument. About 3

seconds later, the instrument exits Setting Mode

automatically. Now you can start measurement.