Follett CVU300 Series Kurulum, Çalıştırma ve Servis Kılavuzu - Sayfa 10
Dağıtıcı Follett CVU300 Series için çevrimiçi göz atın veya pdf Kurulum, Çalıştırma ve Servis Kılavuzu indirin. Follett CVU300 Series 16 sayfaları. 220 v 60 hz ice and water dispensers
Sayfayı Yazdır
Service
Dispense chute cover removal
1. Remove top cover.
2. Pull cover up and off to remove.
3. On push button units, disconnect plug on harness.
Auger motor assembly removal
1. Remove drain pan.
2. Remove thumbscrews from splash guard and remove.
3. Remove thumbscrews from splash panel; lift and pull
forward at base of panel and remove.
4. Unplug auger motor at connector.
5. Remove two 1/4-20 bolts holding auger motor to hold-
down bracket.
6. Remove two thumbscrews from auger motor stabilizer
bracket and set aside.
7. Lift auger motor off.
Gate assembly removal
1. Remove dispense chute cover and auger motor assembly.
2. Remove thumbscrews on each side of clear focus chute
and remove.
3. Remove quick release pin holding dispense gate
assembly and chute.
4. Lift gate up and over hinge tabs, then carefully pull and tilt
to unhook from solenoid link.
5. Pull ice chute toward you to unclip from dimples on chute
mounting bracket.
6. Pull ice chute and gate toward you and out through panel
opening.
7. Lift dispenser mechanism assembly off auger and auger
tube.
Auger and auger tube removal
1. Remove dispense chute cover and auger-motor assembly.
2. Remove side panel of tower.
3. Remove screw holding top auger tube ring to lower ring.
4. Lift auger out of auger tube.
5. Lift out auger tube, turning as needed to clear rivnuts on
side auger motor mounting bracket.
Dispenser wheel removal
1. Remove dispenser top and turn power switch OFF.
2. Remove all ice from bin.
3. Remove drain pan and ice bin access cover below it.
4. Remove splash guard and wheel motor access cover.
5. Unplug wheel motor at connector and remove ground
wire.
6. Remove wheel motor by pulling out two quick release
pins.
7. Lift drive shaft up through hole in countertop.
8. Lift dispense wheel out through drain pan opening.
Dispense chute assembly
gate assembly
ice chute
Dispenser cutaway – front view
auger
tube
ring
10
quick release pins
springs
mounting bracket
auger motor
auger tube
wheel motor
auger
drive
shaft
Front
fi xed ramped
yoke rod with
bracket (below
rotating drive
bar)
fi xed
yoke
rod with
bracket