DPA 4088-F Kullanıcı Kılavuzu - Sayfa 5
Mikrofon DPA 4088-F için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DPA 4088-F 10 sayfaları. Cardioid headband
the cable than the standard MicroDot con-
nector from DPA Microphones. The DPA
MicroDot connector is specially designed
for use with the Kevlar® reinforced cable,
ensuring the maximum possible tensile
strength in the design. In case of failure,
MicroDot spare parts tool, and assembly
tool and assembly guide can be acquired.
Various wireless systems require the use of
electronic components inside the adapter
to optimise the signal level, the DC-offset
filtering and powering of the built-in micro-
phone preamplifier. Using the adapters
from DPA Microphones ensures the correct
electronic circuit with the listed types of
wireless systems at all times. Do not
attempt to employ non-standard adapters
or connectors as you might damage the
microphone preamplifier.
Tighten here
Not here
MicroDot connector
8
Adjusting the 4088 headband
The headband mount is telescopic and is
easily adjusted to fit almost any headsize.
The mount can also be widened by carefully
expanding the distance between the ear
hooks.
The 4088 headband is supplied with the
boom mounted.
To change sides simply click the boom out
of the clips and follow the instructions
below.
· Hold the boom in your right hand when
mounting on the right side and vice versa.
Hold the boom by the cable relief.
· Position your hand with the boom between
the ear hooks and turn the boom around in
the loop. Take your hand with the boom
under the headband and draw it towards you.
· Secure the microphone boom into the two
clips next to the ear hook beneath which
the boom is to be mounted. Next, secure
the boom in the clip in the middle of the
headband. This clip is movable and should
be placed near the end of the microphone
boom, before the cable relief (where the
soft cable begins to be visible). The remai-
ning two clips are not used (unless two
booms are to be mounted on the same
headband).
✗
The soft cable must not be attached
into the clips. The clips are sharp and
you will risk damaging the cable.
9