Carbolite 3216 P5 Kullanım Talimatları Kılavuzu - Sayfa 12
Sıcaklık Kontrolörü Carbolite 3216 P5 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Carbolite 3216 P5 20 sayfaları. Type 3216
Sayfayı Yazdır
Programming
5.2
Running a Program
If using the 3216P5 controller Press Scroll
required Program Number before running a Program.
Table below shows the key presses to run a program
Operation
To RUN a program Press and quickly
To HOLD a
program
To RESET a
program
To RESET a
program after it
has completed
5.3
Program Status
While the program is running in level 1 or level 2, the Home Display shows two values at
any one time:
Process Value
The upper display shows the measured temperature of the furnace (PV).
PSP, Segment Type and Number
The lower display continually alternates between the programs current set value (Program
SP = PSP) and scrolling text, indicating the current status of the program whether RAMP or
DWELLING followed by the segment number.
Additional information can be obtained using the scroll
Working Output Power
From the home display, press Scroll
POWER> This shows the power being used as a percentage.
12
Action
release
+
Press and quickly
release
+
Press and Hold
+
for more than
1 second
Program Ended
Press and Hold
+
for more than
1 second
Or
Press and quickly
release
Ack
until the display shows WRK.OP <WORKING OUTPUT
to display PROG <PROGRAM NUMBER> select the
Indication
Indicator – RUN = On
Scrolling Display – Current Program state
Indicator – RUN = Flashing
Scrolling Display – Program Hold
Indicator – RUN = Off
Scrolling Display - None
Indicator – RUN = Off
Scrolling Text – Program End
Indicator – RUN = Off
Scrolling Display - None
key while the program is running.
MC18-GB – v1.04