Carbolite P5 Kullanım Talimatları Kılavuzu - Sayfa 9

Sıcaklık Kontrolörü Carbolite P5 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Carbolite P5 20 sayfaları. Type 3216

until the display shows. TEXT <ENABLE/DISABLE SCROLLING TEXT>

Press Scroll

Use the Up

Down

4.6

Customer Calibration

The 3216 series of controllers are calibrated for life at manufacture, there may however be

sensor or other system errors, which affect the accuracy of the measured temperature.

Customer calibration can be used to compensate for these errors.

Dual Offset

Dual point calibration uses two offset values at two corresponding temperatures; this

changes the calibration linearly as the temperature increases or decreases.

until the display shows CAL.P (Enter Calibration Code) Use Up

Press scroll

to enter the password code. (Calibration Pass Code = 95). When the correct password

has been entered the display will show PNT.LO. If the wrong pass code is entered the display

will revert to zero pass code, until the correct pass code is entered.

When the correct pass code is entered and PNT.LO (Adjust Low Point) is displayed. Use

Down

to enter the Low Temperature Point, which you want to apply an Offset.

until the display shows OFS.LO (Adjust Low OFFset). Use Up

Press scroll

enter the amount Offset you want to apply to the Low Temperature Point.

until the display shows PNT.HI (Adjust High Point). Use Up

Press scroll

to enter the High Temperature Point, which you want to apply an Offset.

until the display shows OFS.HI (Adjust High OFFset). Use the Up

Press scroll

to enter the amount Offset you want to apply the High Temperature Point.

Once the calibration details have been entered, press scroll

next required parameter or return to the home list. The calibration data will now be protected

by the pass code. To edit the data the above procedure must be followed.

MC18-GB – v1.04

to select ON or OFF

Programming

Down

until the display shows the

Down