Carcam G-800 Kurulum ve Kullanım Kılavuzu - Sayfa 5

Araç Kameraları Carcam G-800 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Carcam G-800 13 sayfaları.

Fixing Belts Installation

Front Camera Installation

1. Fix the car camera to the original car's rear-view mirror. Check the position of the 12v

charger socket and if that is positioned to one side of the dash then run the cable in this

direction from the mirror (shortest route).

2. Run the cable along the front windshield and it should be possible to tuck the cable behind

the windscreen rubber and/or under the head-cloth. TIP: Where you pull any rubber seal back

to open access to the head-cloth or inner panels, don't refit this yet, as you may also be able

to use this route for the rear camera cable.

3. From the top of the windscreen/head-cloth run the cable down the A-pillars. Again it

should be possible to hide the cable behind the door seal rubber and/or behind the A-pillar

panel, which should be accessible when the rubber is pulled back.

4. Feed the cable from here along the bottom of the dash panel/glove box, or if it suits better

under the carpet. Where necessary, cable tie the cable to the back of these panels, or to

existing cables.

5. Insert the charger to the 12v socket. Where there is excess, roll up and cable tie behind the

dash in a suitable position. The front camera installation is now finish.