DPS TS-200 Talimatlar Kılavuzu - Sayfa 2

Su Pompası DPS TS-200 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. DPS TS-200 10 sayfaları.

1.
Disconnect all power sources to ensure the pump will remain inoperative
2.
Allow the pump to cool before starting maintenance
3.
Close the suction and discharge valves if fitted
4.
Vent the pump slowly and cautiously
5.
Drain the pump
When working near the pump, dress appropriately, avoid baggy or loose
items which could get caught in moving parts. Always wear safety clothing,
gloves, safety glasses, helmet etc.
This pump is designed to handle mild industrial corrosives, mud and slurries
containing solids. Do not attempt to pump volatile, corrosive or flammable
liquids that may damage the pump or endanger personnel.
Use lifting and moving equipment with ample capacity and in good repair.
Remove all suction and discharge piping before lifting.
Do not remove any items from an overheated pump. Pressure build up
within the pump can cause parts being disengaged to be ejected with force.
Allow the pump to cool before commencing any maintenance.
Do not operate the pump with a closed discharge valve for any length of
time. Running the pump in this configuration could cause the liquid to boil
and cause the pump casing to explode.
Do not operate the pump without all guards in place over rotating parts.
After the pump has been positioned make sure all the pump mountings and
any fixtures are properly secured and supported before operation.
Safety Warning
www.dieselparts.com.au