Cardin S486 QZ2 Programlama Kılavuzu - Sayfa 2

Uzaktan Kumanda Cardin S486 QZ2 için çevrimiçi göz atın veya pdf Programlama Kılavuzu indirin. Cardin S486 QZ2 2 sayfaları.
Ayrıca Cardin S486 QZ2 için: Programlama Kılavuzu (2 sayfalar)

Sayfayı Yazdır
Cardin S486 QZ2 Programlama Kılavuzu
From the receiver :
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board (diagram above), press the programming button (MEMO). Keep
it pressed down. The LED light of the receiver blinks.
3. While keeping pressed down the button MEMO, press the button you wish to program on
your new remote control until the LED light of the receiver turns off.
4. Let the buttons go.
5. The LED light of the receiver blinks.
6. Press the button on your new remote control again. Let it go.
7. The LED light of the receiver turns off.
8. Repeat this procedure for each button you wish to program.
9. Wait 10 seconds.
10. Your new remote control is programmed.
http://www.remotecontrol-express.com
Programming Manual
- TEL : +44 (0) 207 399 7782 - FAX : +44 (0) 207 927 3151