DR 41416 Güvenlik ve Kullanım Talimatları Kılavuzu - Sayfa 13

Düzeltici DR 41416 için çevrimiçi göz atın veya pdf Güvenlik ve Kullanım Talimatları Kılavuzu indirin. DR 41416 20 sayfaları.

Sayfayı Yazdır

Chapter 4: Maintaining The DR

Regular maintenance is the way to ensure the best performance and long life of your machine. Please refer to this Chapter for

maintenance procedures.

Always remove the Battery Pack before performing any maintenance, or repairs to your Hedge Trimmer.

Blade Lubrication

The Blade Set is made from high quality hardened steel. With normal usage;

they will not require re-sharpening. However, if you accidentally hit a wire fence,

stones, glass, or other hard objects, you may put a nick in the Blade Set. There

is no need to remove this nick as long as it does not interfere with the

movement of the Blade Set. If it does interfere, make sure to remove the Battery

Pack from the Hedge Trimmer and use a Fine-Toothed File or Sharpening Stone

to remove the nick

Supplies Needed:

•

Light Weight Machine Oil

Before each use, remove any debris on the Blade Set and apply lightweight

machine oil along the Contact Points of the Top and Bottom Blades (Figure 11).

Make sure the Handles remain clean and dry of Oil.

Battery LED Lights

Check the charge percentage of your 62V Battery by pushing the Indicator

Button on the front of the Battery (Figure 12). The number of Green LED

indicators will tell you the % of power left in the battery. 1-25%, 2-50%, 3-75%

and 4-100%.

If you press the Indicator Button and only the fourth LED flashes, the Battery

needs charging.

Charger indicator Lights (Figure 13)

Red LED Lit, green LED is not lit; The Charger is plugged in but the Battery is

not installed (no load condition).

Green LED blinks, red LED is not lit; Battery is charging normally.

The green LED is on, red LED is not lit; Battery is fully charged.

Green LED is not lit, red LED blinks; There is a fault with the Battery or Charger.

Remove the Battery from the Charger and wait about 30 minutes, then reinsert

the Battery into the Charger.

If the Battery does not hold its charge for very long under normal conditions or

it simply won't hold a charge, then replace it. You can purchase a replacement

Battery directly from us at

PRO-62V HEDGE TRIMMER

www.DRpower.com

Top

Blade

Bottom

Blade Contact

Blade

Points

Figure 11

Indicator

Button

Figure 12

Green

LED

Figure 13

Battery

Red

LED

Charger