AMS AS5147 Kullanıcı Kılavuzu - Sayfa 11
Anakart AMS AS5147 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AMS AS5147 13 sayfaları. Usb interface & programming box
Ayrıca AMS AS5147 için: Manuel (9 sayfalar)
Sayfayı Yazdır
USB I&P Box
User Manual
5
Software
5.1
GUI Overview
Also included in your USB I&P Tool is a USB stick with the software.
The software is needed for programming the Magnetic Position Sensor on your computer.
When you copied the software from the USB stick to your computer please click on it and follow
the instructions of the Install Wizard through the installing procedure.
The software is compatible for Windows XP and newer versions.
In
Figure
10:
you can have a look at the starting page after finishing the installing and no device
connected.
Figure 11
shows the GUI while a Programmer Box connected
Figure 10:
Screenshot of the GUI's starting page while no Programmer is connected
C
A: Select the Device (only possible when a I&P Box is detected)
B: Check if the Programmer will be detected (or there is no bootloader on the I&P Box)
C: For firmware updates click on Help and Firmware Update, for further Information about
this topic refer to
5.2
www.ams.com
A
Revision 1.4 / 09/09/2015
B
page 11/13