Dr. Clark VariZapper 2.0 Manuel - Sayfa 12

Kişisel Bakım Ürünleri Dr. Clark VariZapper 2.0 için çevrimiçi göz atın veya pdf Manuel indirin. Dr. Clark VariZapper 2.0 15 sayfaları.

The VariGamma 2.0

4.1.8 Run the last program (session)

In the Main Menu panel the first option available is "Run last program > - ProgramName -". Choosing this

option, you will run the last used or uploaded program. Press the Turnwheel button to select it, the

device will ask to connect the device to the body and confirm with

to start.

Fig. 18

When the connection check is completed:

• Successful: if the connection check is successful select

The device will then show the running panel where you can follow the progress of the program (Fig. 20).

At the center of the panel is a progress bar, the voltage, the frequency and the wave type. At the top of

the display starting from the left are indicated the time remaining to finish the program, the step currently

running and the total number of steps. (Skipping steps see paragraph 4.1.6.2.)

• Poor connection: if the connection is not good the device will show a POOR CONNECTION Panel (Fig.

21). You can select

continue without connection check (Note: there is no connection control for the Zappicator Program).

When the program is completed, select

Fig. 20

From the Main Menu Panel you get to the program library by selecting „Select program". Scroll with the

Turnwheel button and press to select.

Fig. 23

The program menu lists all of the programs on the device. The screen is divided in three sections (Fig.

23):

• left section: list of the standard programs (Normal zapping, Continuous Zapping and Zappicator). To

navigate inside the list, rotate the Turnwheel. Press Turnwheel to make selection.

• right section: all the programs uploaded. Rotate the Turnwheel to get to the desired program. If there is

more than one screen (6) of programs, you can rotate down or up to the next screen OR

• get to the bottom section (icon bar), where you can navigate screens with the up and down arrows.

•

To move between the left, right and bottom section: use the Direction buttons (left/right) on the device.

Those are the two buttons with the arrow left and right of the Turnwheel. You can not navigate between

the sections with the Turnwheel.

Fig. 19

to retry the connection check after checking the electrodes or select

to return to the Main Menu (Fig. 22).

Fig. 21

(Fig. 18) for the connection check

to run the program (Fig. 19).

Fig. 22