AMSEC PB3 Talimatlar - Sayfa 3
Kilitler AMSEC PB3 için çevrimiçi göz atın veya pdf Talimatlar indirin. AMSEC PB3 4 sayfaları. 5-button electronic lock
Sayfayı Yazdır
¾ The PB3 lock has a Penalty Lockout feature to prevent tampering (code testing).
• This feature will cause the lock to stop accepting input for five (5) minutes after four (4)
incorrect opening attempts.
• While in Penalty Lockout, the lock will respond to any keystroke with eight (8) rapid
flashes of the red LED lamp, along with beeps.
¾ While in Penalty Lockout, the LED lamp will flash once every five (5) seconds and beep.
¾ When a correct code has been entered, Primary or Backup, the Red LED Lamp will light for
three (3) seconds, indicating the lock can be opened.
• To open the lock, turn the knob Clockwise 90 degrees.
¾ The PB3 lock uses four (4) standard AA Alkaline Batteries.
• We recommend Duracell® or Eveready Energizer® batteries for best performance.
• The PB3 lock should open approximately 5000 times with fresh, good quality batteries,
depending on installed options and user habits.
¾ The PB3 lock provides a backup power port to prevent lockout if the internal battery is
allowed to go dead.
¾ Loss of power will not erase codes. The PB3 lock uses "non-volatile" memory.
¾ On the side of the lock body, you will find a small white button used to program codes and
features.
• This lock is not waterproof, and is not intended for outdoor use. Exposure to
extreme conditions or excess moisture may cause a malfunction, and will void the
Manufacturers Warranty.
¾ The PB3 Lock has a power-saver feature that puts the lock in sleep mode after 30 seconds if
it has been left unlocked.
Programming
The PB3 lock is programmable, so the user can change codes and beeper off feature.
To Set the Primary Code:
¾ Lock the safe OPEN.
¾ Press the change button once.
¾ Enter five (5) keystrokes for the new primary code.
¾ Test the new code.
To Set the Backup Code:
¾ Lock the safe OPEN.
¾ Press the change button twice.
¾ Enter eight (8) keystrokes for the new backup code.
¾ Test the new code.
To Turn the Sound of the Beeper Off:
¾ Lock the safe OPEN. Press the change button three times; then press button number 1. To
return the beeper to On, Repeat the same steps.