AMSEC DL4000 Manuel

Kasalar AMSEC DL4000 için çevrimiçi göz atın veya pdf Manuel indirin. AMSEC DL4000 2 sayfaları.

Sayfayı Yazdır

Each AMSEC safe is professionally hand-crafted with quality materials and is equipped with a precision-

quality, digital lock. To become familiar with the lock, operate the lock (as outlined below) several times

before closing the door and locking the safe.

OPERATION INSTRUCTIONS:

• Don't slam the door. Extreme shock can damage the lock or jam the boltwork.

• Don't shut the door with the boltwork in the locked position. Damage to the boltwork and

marring the safe's finish may result.

• Don't stack contents of the safe so that the door must be forced shut. Jamming of the boltwork

may result.

• Don't store the combination card inside the safe.

• Don't use oil, grease or any other lubricant on the digital lock.

• Keep all moving parts clean and free from obstruction, water and grease.

• If you experience a difference in the feel of the operation, inconsistency or difficulty opening or

operating the safe, DO NOT LOCK THE SAFE. Immediately contact the security store from whom you

purchased the safe. If this is not practical, contact the AMSEC service department at 951-685-9680,

Ext. 1036.

STEP 1 - OPENING THE SAFE

1-Press the # key.

2-Enter user code (Factory default is: 1-2-3-4)

3-Press the # key.

4-The LCD display will turn Blue and show Open.

5-Turn the Knob clockwise (Right) and open door.

For models WES149, ES149 and ES1814: Turn the

knob counter-clockwise (Left) and open door.

6-If the wrong user code is entered the display will

show "Error". If the wrong code is entered 3 times

consecutively, an alarm will sound for 10 seconds

and the safe will be locked out for 3 minutes.

7-If you do not want your personal code shown on

the LCD display press the # key followed by the *

key). The LCD display will turn Blue. This function

will be cancelled after each opening.

Emergency Keyhole Cover

Turn Knob

or Aux-Key

DIAGRAM 1.0

Power

Override Hole

STEP 2 - CHANGING THE USER CODE

1-Open the safe by following step 1.

2-Press the Green set up button (Located on the

back cover or the hinge side of the back door

cover), the LCD display will turn Blue.

3-Enter your new user code (1-8 digits).

4-Press the # key.

5-The LCD display will turn Blue and show IN.

6-The LCD display will briefly show your new code.

7-Your new user code is now set to open the safe

NOTE: It is highly recommended to leave the

safe door open and practice your new code

several times before closing the door.

LCD

Display

Keypad