DR. Heater DR-966 Kullanıcı El Kitabı - Sayfa 13
Isıtıcı DR. Heater DR-966 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. DR. Heater DR-966 13 sayfaları. Wall / ceiling mount heater
Ayrıca DR. Heater DR-966 için: Kullanıcı El Kitabı (16 sayfalar)
Sayfayı Yazdır
TROUBLESHOOTING
If your heater fails to operate, please follow these procedures:
This heater is intended to be a ceiling-mounted heater. It has a
thermal cut-off protection. If the thermal cut-off protection trips, then,
switch off the power. Switch off the circuit breaker.The unit
should reset automatically after 10 minutes. If the thermal cut-off
protection trips again, consult a certified electrician to determine the
reason for overheating.
Problem
Probable Cause
Overheat protection has
temporarily deactivated the
heater.
Room temperature has been
Unit is
warmed up to thermostat
not
setting.
heating.
Breaker/Fuse has been
tripped.
Check & ensure there are no
combustible materials within
0.9 meters (3 feet) surrounding
the heater.
The
A drop of oil fell on the heating
heater is
coil during the manufacturing
producing
process. It will quickly
a burning
evaporate and should not
smell.
occur again.
Ensure a minimum clearance
of 36 inches (90 cm) from
both sides and rear of heater
to adjacent walls.
PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER
YOURSELF. DOING SO COULD CAUSE DAMAGE OR PERSONAL
INJURY.
Solution
Turn the heater OFF;
the circuit breaker.
minutes before turning on the
heater
To increase the room temperature,
adjust thermostat control knob to a
higher setting
Check your electrical box to
confirm the breaker has not been
blown. This may occur if the
receptacle is shared between other
high consumption appliances.
Remove any combustible items
from the heater.
Ensure room in which heater is
situated is well ventilated.
Reposition the heater so there is
enough space around the heater to
the adjacent walls.
Switch off
. Wait 10
13