AIRSLED AM2400-VS Kullanıcı El Kitabı - Sayfa 5

Jacks AIRSLED AM2400-VS için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. AIRSLED AM2400-VS 8 sayfaları. Standard & heavy-duty appliance mover

Sayfayı Yazdır
Figure 9
CARE AND MAINTENANCE
Airsled systems are proudly made in the USA using the highest quality materials. If properly used and maintained,
your Airsled product will have a long service life. To ensure optimal performance and longevity, we recommend the
following:
•
Keep the edges of the air beams from striking hard objects.
•
When moving or repositioning the air beams, avoid dragging the corners.
•
Avoid lifting and carrying the air beams by the inlets. Carrying the air beams by only the inlets may
cause them to come loose over time.
•
Periodically inspect the blower filter and bag depending on model. These components should be
cleaned to ensure peak performance of the system's blower.
•
Check the rubber fabric for rips and dirt. If dirty, water with a mild detergent can be used to clean
them as well as household cleaning sprays such as Windex
Armor All
®
is recommended.
•
If you find any rips in the fabric, please see the Repairs and Refurbishment section.
REPAIRS AND REFURBISHMENT
Wear and tear over time especially with frequent use may cause components to fail. Airsled offers
refurbishment services that can restore your aluminum air beams to as-new condition. More information
can be found on www.Airsled.com. Due to safety and regulatory concerns, Airsled cannot refurbish the
blower. Airsled also sells replacement parts. Please see detailed parts list in Exhibit 1. Any repairs
performed by the end-user should be considered temporary. We recommend contacting Airsled to
determine the proper course of action based on the nature of the issue. Some common, temporary
repairs that can be performed in the field include:
Rips in the rubber fabric. Small rips can be temporarily repaired with duct or electrical tape. Before
applying tape, the area must be cleaned and dried. We recommend returning your air beams to
Airsled to be fully refurbished if rips are discovered.
Cracked hose inlet. If you notice a crack in the plastic inlet connected to the air beam, you can wrap
the outer edge in tape after the surface has been cleaned and dried. We recommend that you replace
the inlet which Airsled sells.
Loose hose connections. Over time, the soft ends of the hoses may become stretched out causing
them to lose their snug fit. You can temporarily wrap the male ends with tape to establish a tighter
seal. We recommend that you replace the hoses which Airsled sells.
. To restore the rubber fabric's shine,
®
70 – A Aleph Dr.
Support Email:
Toll Free Number: 1-800-AIRSLED (1-800-247-7533)
Newark, DE 19702
Page 4 of 7
Figure 10