Electrolux 727574 Manuel - Sayfa 28
Buzdolabı Electrolux 727574 için çevrimiçi göz atın veya pdf Manuel indirin. Electrolux 727574 34 sayfaları. Vertical refrigerators
Ayrıca Electrolux 727574 için: Kullanıcı Kılavuzu (18 sayfalar)
Refrigerated models with fully insulated door
Refrigerated models with glass door
Freezer models with fully insulated door
Freezer models with glass door
Refrigerated models with separate compartments
Refrigerated/freezer models with separate compartments
Refrigerated models with separate compartments and 3 doors
E
INSTALLATION AND ASSEMBLY
E.1
Introduction
WARNING
Refer to "Warning and Safety
Information".
To ensure correct operation of the appliance and maintain safe
conditions during use, carefully follow the instructions given in
this chapter.
Check and, if necessary, level the appliance after positioning.
Incorrect levelling can cause appliance malfunctioning.
CAUTION
Before moving the appliance make sure
the load bearing capacity of the lifting
equipment used is suitable for its weight.
NOTE!
Appliances with incorporated refrigerating unit
must be handled upright. If the appliance is
handled in a horizontal position, make sure to wait
a few hours in upright position before making it
operational.
CAUTION
• Install the appliance in a ventilated
place, away from heat sources such
as radiators or air conditioning systems,
to allow correct cooling of the refriger-
ating unit components.
• Never cover the condenser, even tem-
porarily, as this can compromise its
proper operation and therefore that of
the appliance.
• The machine must be taken to the
place of installation and removed from
the packing base only when being
installed.
E.2
Customer's responsibilities
The tasks and works required of the Customer are:
• check the floor planarity on which the appliance is placed;
• arrange an earthed power socket of suitable capacity for the
input specified on the data plate;
• provide a high sensitivity manual-reset differential thermal
magnetic switch;
NOTE!
For information regarding the electrical connection,
refer to "A.11 Electrical connection".
28
Temperature range in compartment
E.3
Unpack the appliance carrying out the following
operations:
• if present, cut the straps and remove the protective film,
taking care not to scratch the surface if scissors or blades
are used;
• if present, remove the cardboard top, the polystyrene
corners and the vertical protection pieces;
• for appliances with stainless steel surfaces, remove the
protective film very slowly without tearing it, to avoid leaving
glue stuck to the surface;
• should this happen, remove the traces of glue with a non-
corrosive solvent, rinsing it off and drying thoroughly;
• it is advisable to go over all the stainless steel surfaces with
a rag soaked in paraffin oil in order to create a protective film.
E.4
The packing must be disposed of in compliance with the
current regulations in the country where the appliance is used.
All the packing materials are environmentally friendly.
They can be safely kept, recycled, or burned in an appropriate
waste incineration plant. Recyclable plastic parts are marked
as follows:
The parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where the
appliance is used.
E.5
Install the appliance, taking all the safety precautions required
for this type of operation, also respecting the relevant fire-
prevention instructions.
If the machine is installed in a place where there are corrosive
substances (chlorine, etc.), it is advisable to go over all the
stainless steel surfaces with a rag soaked in paraffin oil to
create a protective film.
Arranging the machine:
• position the machine in the required place;
• adjust the height and levelling with the adjustment feet, also
checking correct door closing.
-2/+10
+2/+10
-22/-15
-20/-15
-2/+10
-2/+10
-2/+10
-22/-15
-2/+10
-2/+6
Unpacking instructions
Disposal of packing
Polyethylene
• Outer wrapping
• Instructions bag
Polypropylene
• Straps
Polystyrene foam
• Corner protectors