Electrolux 807650601 Kullanım ve Bakım Kılavuzu - Sayfa 30

Buzdolabı Electrolux 807650601 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Electrolux 807650601 39 sayfaları.

3
Changin
TheWater and Air Filters
Your refrigerator is equipped with separate water and
air filtering systems. The water filter system filters all
dispensed drinking water, as well as the water used to
produce ice. The air filter removes odors and impurities
from the refrigerator compartment.
NOTE
The control panel includes controls to monitor the
status of your water and air filters. See the Controls
section for more information.
About your advanced
water filter
The PureAdvantage rMNGFC 2000 ice and
water filter system is tested and certified t_
NSF International to NSFiANSI Standards 42
and 53 for the reduction of claims specified on
the performance data sheet.
4
Push Water Filter Button
Unpack the new filter cartridge and remove the
two protective caps covering the inlet and exit of
the filter. Slide the filter gently into the housing
until it stops against the snap-in connector at the
back of the housing.
Do not use with water that is microbiologicalty unsafe or of
unknow_q quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts.
,, Rated Capacity - 400 gallons for
PureAdvantage
rMice and water filter
,, Rated service flow- .5 gallons per minute
,, Maximum Rated Pressure - 100 pounds per
square inch
*
Recommended Minimum Operating Pressure: 30
pounds per square inch
o Operating Temp.: Min. 33 ° F, Max. 100 ° F
Water fimter
The water filter is located at the lower left side of the
fresh food compartment.
Replacing your PureAdvantage
TM
water filter
In general, you should change the water filter every six
months to ensure the highest possible water quality. The
Water Filter Status light on the Touch Panel prompts
you to replace the filter after a standard amount of water
(400 gallons) has flowed through the system.
Push firmly until the cartridge
snaps into
place (you should
hear two clicks). When fully
engaged, the front of the filter cartridge should be
flush with the filter release button.
If your refrigerator has not been used for a period of
time (during moving for example), change the filter
before reinstalling the refrigerator.
It is not necessary to turn the water supply off to
change the filter. Be ready to wipe up any small
amounts of water released during the filter replacement.
1 Turn Off the ice maker on the control panel.
2
Push the filter release button above the cartridge
to disconnect it.
3
Slide the old water filter cartridge straight out of
the housing and discard it.
ReinstallWater Filter
6 Turn On the ice maker at the control panel.
7
Press a drinking glass against the water
dispenser while checking for any leaks at the filter
housing. Spurts and sputters may occur as the
system purges air out of the dispenser system.
8
Prime the water supply system as described
previously.
9
Press and hold the Filter Status button on the control
panel for three seconds. When the display changes
from Replace to Good, the status has been reset.