Electrolux 95G Talimat Kitapçığı - Sayfa 19
Buzdolabı Electrolux 95G için çevrimiçi göz atın veya pdf Talimat Kitapçığı indirin. Electrolux 95G 20 sayfaları. Gas and mixed fuel cookers
Ayrıca Electrolux 95G için: Talimat Kitapçığı (20 sayfalar), Talimat Kitapçığı (20 sayfalar), Kullanım Kılavuzu (24 sayfalar)
Electrical connection
Something not working
The flow of gas seems abnormal
Gas smell in the room
The oven doesn't heat
Cooking time is too long
The cooker produces smoke
The oven lamp doesn't work
Never look for an escape of gas with a
match; use instead soap and water.
All manuals and user guides at all-guides.com
The manufacturer refuses any responsability in
cases where normal safety measures are not
observed.
Maintenance -Technical assistance
The gas cocks must be periodically lubricated to ensure good
working and safety. Maintenance should be performed as
follows:
Reassemble the whole with utmost care performing the
operations described above inversely.
Original spare parts
This machine, before leaving the factory, has been tested and
studied by many experts and specialists, in order to give you
the best results. Any repair work which needs to be carried out
should be done with the utmost care and attention. For this
reason we reccomend that for any problem you contact the
dealer who sold it to you, or our nearest authorized Service
Centre, specifying the nature of the problem and the particular
model which you own.
The guarantee
Your new cooker is covered by guarantee. You will find the
guarantee certificate enclosed. If you are missing anything,
contact your retailer, giving the date of purchase, model, and
the registration number which is printed on the identification
plate.We ask you to bear in mind that for the guarantee to be
operated, it is necessary to fill in and send the larger part of
the guarantee to Electrolux Technical Assistance & Service
within 8 days of purchase, so that we can provide registration.
We advise you that the smaller part of the certificate, as well
as your receipt and proof of purchase, should be shown when
required to personnel of Electrolux Technical Assistance &
Service. Without following this procedure, the repair personnel
will have to charge you more for the repair.
Phase
Ground (yellow - green)
Fig. 31
Remove the knob and panel after having taken out
fastening screws.
Loosen the two screws located at the sides of the cock bar.
Remove the cone and clean it carefully.
Then, apply a thin layer of grease non soluble in water,
suitable for gas cocks. Take care not to obstruct the gas
flow holes by an excess of grease.
FO 0480
Neutral
wire
19