Electrolux ARA34280W Kullanıcı Kılavuzu - Sayfa 12

Buzdolabı Electrolux ARA34280W için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Electrolux ARA34280W 16 sayfaları.

Sayfayı Yazdır

12 electrolux

accessible. If the mains supply cable is dam-

aged, it must be replaced by a certified sup-

ply cable. This must be done only by a skilled

person, the seller or the manufacturer. The

appliance must not be connected via an ex-

tension cable, a multiple socket or a multiple

connector (risk of fire). Make sure the earth-

ing connection complies with the regulations

in force.

We will accept no responsibility in the event

of accidents or incidents caused by non-ex-

istent or defective electrical earthing connec-

tions.

Rear spacers

Inside the appliance you find two

spacers which must be fitted as shown

in the figure.

Slacken the screws and insert the spacer

under the screw head, then retighten the

screws.

Removing the shelf holders

Your appliance is equipped with shelf retain-

ers that make it possible to secure the

shelves during transportation.

To remove them proceed as follows:

1. Move the shelf holders in the direction of

the arrow (A).

2. Raise the shelf from the rear and push it

forward until it is freed (B).

3. Remove the retainers (C).

Door reversibility

Warning! Before carrying out any

operations, remove the plug from the

power socket.

Important! To carry out the following

operations, we suggest that this be made

with another person that will keep a firm hold

on the doors of the appliance during the

operations.

To change the opening direction of the door,

do these steps:

1. Open the door with the appliance in the

upright position. Unscrew the screws

and remove the upper door plastic trim.

2. Remove the little plastic cover (d) from

the door plastic trim and install on the

opposite side.

3. Lay down the appliance back side down.