Electrolux BRT217TGW0 Kullanım ve Bakım Kılavuzu - Sayfa 8
Buzdolabı Electrolux BRT217TGW0 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Electrolux BRT217TGW0 18 sayfaları. Top mount refrigerator
Sayfayı Yazdır
TO REMOVE REFRIGERATOR HANDLE:
(Handles may be easier to reverse while doors are off.)
Figure
! Styte
HandJes
1.
Remove two screws attaching handle to top of refrigerator
door.
2.
Remove screw attaching bottom of handle to door.
3.
Remove two hole piugs and hinge pin plug on top of door
and install on opposite side. Use Phillips head screwdriver
to remove plastic screw plug from front of door and install
on opposite side
Figure
2 Style
Handles
1,
Remove two screws attaching handJe to top of refrigerator
door.
2.
Swing top of handle away from door and slide handle
down and off of dovetail button.
3.
Remove screw and dovetail button and install on other
side, moving hole plugs from corresponding
holes to
opposite side.
TO ATTACH REFRIGERATOR
HANDLE:
Figure
1 Style
Handles
1.
Secure bottom of handle with screws.
2.
Secure top of handle with screws.
Figure
2 Styte
HandJes
1.
Start with handle offset away from door. Place bottom of
handle over dovetail button, swing handle into an upright
position and pull upward, locking it into place.
2.
Secure top of handle with screws.
TO REMOVE REFRIGERATOR HANDLE:
(Handles may be easier to
reverse while doors are off.)
1.
Remove two screws
attaching handle to top of
refrigerator door.
2.
Remove button plug
using edge of putty knife.
3.
Remove screw on side of
refrigerator door and
remove handle.
4.
Reverse freezer and
refrigerator
handles as
shown in figure 3.
Figure 3 - Handle Reversal
TO ATTACH
REFRIGERATOR
HANDLE:
1.
Secure side of handle to
door and replace plug
...................
button.
2.
Secure handle to top of
door,
Button
Plu
Refrigerator Door Without Trim
TO ATTACH TRIM:
1.
Slide both trim locks out of trim.
2.
Insert new adhesive trim locks contained in your literature
pack.
w
3.
install trim to handle by sliding under base of handle.
Carefully align trim and press down at trim lock locations.
4.
Use rubbing alcohol to remove any adhesive residue from
old trim lock locations.
Full
Length
'
Figure
1
Dovetail
:_k Handme
ovel
Dovetaim
q
Adhesive
--TrimLocK
FulJ
f
J
Figure 2