Advanced Control Technologies HomePro ZDW103 Manuel - Sayfa 6

Ev Otomasyonu Advanced Control Technologies HomePro ZDW103 için çevrimiçi göz atın veya pdf Manuel indirin. Advanced Control Technologies HomePro ZDW103 6 sayfaları. Z-wave radio frequency (rf) controlled, 500w, 120 vac, wall mounted 3-way dimmer

Sayfayı Yazdır

You can assign an "SUC Route" to the ZDW103. Refer to your Controller's instructions on how to do this (if it supports

it). Assigning an SUC Route to the ZDW103 allows it to request an update of the Z-Wave devices that are between

it and the Z-Wave device to which it was trying to transmit. The ZDW103 will only request an update when a

transmission fails.

SPECIFICATIONS

Power

Maximum Load

Signal (Frequency)

Range

INTEROPERABILITY WITH Z-WAVE™ DEVICES

A Z-Wave™ network can integrate devices of various classes, and these devices can be made by different

manufacturers. The ZDW103 can be incorporated into existing Z-Wave™ networks.

The top or bottom of the ZDW103 switch can be used to carry out inclusion, association, or exclusion.

WARRANTY

For warranty and general product information visit our web site at www.act-solutions.com

ABOUT ZDW103'S CERTIFICATION

The ZDW103 is certified to comply with applicable FCC and IC

rules and regulations governing RF and EMI emissions.

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) This device must accept any interfer-

ence received, including interference that may cause undesired

operation.

FCC NOTICE

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

- Increase the separation between the equipment and receiver.

- Consult the dealer or an experienced radio/TV technician for help.

IC NOTICE

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device

must accept any interference, including interference that may cause undesired operation of the device.

Z-Wave ZDW103 Series 200, Release 2.2 Instructions

P/D 020708

120 VAC, 60 Hz

500 Watts for control of permanently installed incandescent lamp

fixtures only (not for control of receptacles)

908.42 MHz

Up to 100 feet line of sight between the Controller and /or the

closest HomePro Receiver Module

0760-01

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC.