Dragonfly Battle Born BB8D Kılavuz ve Kurulum Kılavuzu - Sayfa 5

Kamera Aksesuarları Dragonfly Battle Born BB8D için çevrimiçi göz atın veya pdf Kılavuz ve Kurulum Kılavuzu indirin. Dragonfly Battle Born BB8D 8 sayfaları. 270ah 12v deep cycle lifepo4 battery

Sayfayı Yazdır

Connecting the Batteries in Series

Why Connect in Series?

When batteries are connected in series, current capacities remain the same, but the system voltage is additive. For

example, two BB8D batteries connected in series form a nominally 24V system (shown in Fig. 4) and should be charged

using a bulk and absorption voltage of 28.8V, and a float voltage of 27.2V.

How to Make a Series Connection

Note: Battle Born 8D Batteries are capable of being connected in series up to 48V. DO NOT exceed a 48V setup or you will void the battery's

warranty

1. Before making any connections, make sure to charge each battery up to 14.6V with a proper lithium charger. ALL

BATTERIES SHOULD BE AT THE SAME STATE OF CHARGE PRIOR TO CONNECTING, otherwise you will encounter

balance issues within your system. You can check your battery's state of charge with a multimeter.

2. Identify the positive and negative terminals. These are labeled and color-coded

negative (–).

3. Determine the appropriate finishing hardware set you will use. Verify that your bolt can fully seat into

the nylok insert of the nut. If multiple lugs are used, longer bolts may be required for the bolt to fully seat into

the nylok insert of the nut.

4. Make the proper cable connections to the negative of the first battery. Please reference Fig. 1 for the proper order

of hardware.

5. When connecting to your battery terminals,

to the specification of 9 to 11 ft-lbs. Failure to adequately secure connections can result in severe damage and will

void your warranty.

6. Connect the other end of your cable to the positive terminal of the other battery you are connecting to. Repeat step

Repeat steps 3-6 for additional batteries, but DO NOT exceed 48V. An example of a correct series

connection can be found below in Fig. 4.

How to Properly Charge the Batteries

To properly charge your Battle Born Batteries, you will want to verify that any charging component in your system is

capable of being programmed for the following specifications. Charging components can include, but are not

limited to converters, inverter chargers, solar charge controllers, DC to DC chargers, etc.

•

Bulk/Absorption: 14.2V – 14.6V

•

Absorption Time: 60-90 minutes per battery (for parallel string)

•

Float: 13.4V – 13.8V

•

Equalization: 14.4V/ Disabled

•

Temperature Compensation: 0/Disabled

Charge Rate: .5c

•

NOTE: Not all chargers are capable of multistage charging. If yours is not, you will want to verify it can be programmed for the Bulk/Absorption voltage and have the

other items mentioned disabled if applicable. Consult your charger's manual or the

Battle Born Batteries 8D Manual

DO NOT

Figure 4: Two 8D Batteries Connected in Series to create a 24V 270Ah Battery Bank

red for positive

finger tighten. Use a torque wrench to torque your hardware

manufacturer.

(+), black for