Dragonfly DFM-TAB-92-43 Kurulum Kılavuzu - Sayfa 6
Motorlu ekran Dragonfly DFM-TAB-92-43 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dragonfly DFM-TAB-92-43 17 sayfaları. Dfm-tab screens
Ayrıca Dragonfly DFM-TAB-92-43 için: Kullanıcı El Kitabı (8 sayfalar)
Sayfayı Yazdır
DFM-TAB Installation Manual
5. Installation
5.1. Installing the Brackets
5.1.1. Mounting Brackets
The mounting brackets can be attached anywhere on the screen housing, but they should be about 4" from
each end to ensure that vibration or noise is prevented during operation.
1. Measure the width of the Projector Screen Housing (Dim. "B" in Section 12. Dimensions and Weight) and
subtract 8" to estimate the distance the brackets should be mounted apart.
2. Mark the location of one bracket on the mounting surface, then measure to the planned location of the second
bracket. Adjust the general location of each bracket to allow for both to mount securely to wood or concrete.
Be sure that wall-mounted brackets are level before installation.
3. Mark the screw holes for each bracket and install them:
Mounting to Wood Joists or Studs
Use the included mounting screws to secure the projector
mount brackets to the surface.
•
No pre-drilling is necessary for most applications.
•
Use 4 of the 8 included screws to mount each bracket
as pictured.
Warning!
larger than a 5/32" bit. Larger holes will not
properly grip the threads, and the projection
screen could fall.
Mounting to Concrete Ceiling or Wall
Use the included anchors for the mounting holes and install
the screws into the anchors.
•
Use a 7/32" masonry bit to drill a hole for each screw.
•
Insert the anchors into the holes until they are flush.
•
Do not install anchors into mortar joints.
•
Use 4 of the 8 included screws to mount each bracket
as pictured.
Pg. 6
Top of Brackets Must Be Level
Top of Screen Housing Will Be Here
Approximate Distance = Screen Housing Width Minus 8"
If holes are pre-drilled, use no
Wall Mount
Ceiling Mount
Wall Mount
Ceiling Mount
© 2013 Dragonfly