Dragster DAF 5001 Kurulum ve Kullanım Kılavuzu - Sayfa 10
Amplifikatör Dragster DAF 5001 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Dragster DAF 5001 18 sayfaları. Power amplifiers
Ayrıca Dragster DAF 5001 için: Kurulum ve Kullanım Kılavuzu (17 sayfalar)
Sayfayı Yazdır
DAF 3001/5001/7001 -
#7
oR
to AMp –
to AMp +
Dvc 2 ohM WirED in pArAllEl = 1 ohM
#8
DAF 3001/5001/7001 -
FOUR 4-OHM SUBWOOFERS IN PARALLEL
4 ohM SUBWooFeR In PARAllel WIll eqUAl A 1 ohM Mono loAD
4 ohM SUbWooFEr
4 ohM SUbWooFEr
18
18
1-OHM MONO LOAD SUBWOOFER WIRING
2 ohM FinAl WooFEr loAD
2 ohM FinAl WooFEr loAD
4 ohM SUbWooFEr
4 ohM SUbWooFEr
DAF 3001/5001/7001 -
BRIDGING TWO MONO CHANNEL AMPLIFIERS
#9
Use heavy gauge wire to connect both amplifiers speaker negative (-) connection.
When bridging two DAF mono amplifiers, the final impedance of the bridged channel
shall be not less trhan 2-ohm.
Under no circumstances can you bridge different models of amplifiers.
rcA hEAD Unit SignAl to MAStEr AMp only!
no rcA cAblES to bE AttAchED to SlAvE AMp
PoSItIve teRMInAl oF WooFEr to
MAStEr AMpliFiEr poSitivE tErMinAl
2-ohM FinAl iMpEDAncE loAD
MInUS teRMInAl oF WooFEr to
SlAvE AMpliFiEr poSitivE tErMinAl
MAStEr AMp in MAStEr MoDE
RCA CABle: fully adjusted signal
SlAvE AMp in SlAvE MoDE
is transferred from Master to Slave amp
19
19