Drainvac COMMERCIAL 2AC9932-S Kullanıcı El Kitabı - Sayfa 9
Elektrikli Süpürge Drainvac COMMERCIAL 2AC9932-S için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Drainvac COMMERCIAL 2AC9932-S 15 sayfaları.
Ayrıca Drainvac COMMERCIAL 2AC9932-S için: Kullanıcı El Kitabı (15 sayfalar)
2AC9932-S INSTALLATION
• Repeat steps 1 to 5 to install the 2AC9932-S. Remember to connect the
2AC9932-M with the 2AC9932-S in parallel as illustrated.
24V wires are supplied with the units.
• Connect both units with the 24V wires to the low voltage block.
16
All manuals and user guides at all-guides.com
The following pages illustrate piping diagrams, typical installations and the parts
that we recommend for an optimum performance of your central vacuum system.
GENERAL INFORMATION
An air outlet leading outside must always be installed on a two-motor unit.
•
Make sure that the evacuated air does not lead under a carport.
• If your unit includes two motors, it is important to use metal piping and couplings
for the air outlet.
• To determine where to locate the wall inlets, use the length of the vacuum hose as
a basis, measuring the furthest point from the wall where the wall inlets are to be
installed. Do the same for all the wall inlets until all areas of the house or building
can be reached with the vacuum hose, by moving it from one wall inlet to another.
• If your walls are made of gypsum board, never install a wall inlet in the centre
of the wall. Drill the holes for the wall inlets close to a wall stud or a door frame.
• Any screw length can be used if you install the piping as illustrated in Figure A.
• If you install the piping as illustrated in Figure B, make sure to position the small
screw in the right place to avoid piercing a hole through the pipe.
• Always use a short elbow when connecting the wall inlets (Figures A and B) to
prevent long objects (for example, a pencil) that may have been vacuumed by
mistake from blocking the piping further on.
PIPING INSTALLATION
Short elbow
Figure A
Small screw
Figure B
17