Drainvac Automatik Series Kullanıcı El Kitabı - Sayfa 2

Merkezi Vakum Sistemleri Drainvac Automatik Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Drainvac Automatik Series 18 sayfaları.

Sayfayı Yazdır

TITRE

INTRODUCTION

We wish to thank you for your trust and congratulate you for having chosen a Drainvac product. It is a sound

investment that will satisfy your vacuuming needs for years to come. The concept of Drainvac's Automatik

central vacuum cleaners is unique and patented. They are manufactured and checked at our plant by our

qualified staff who have been specifically trained to this end. A number of installation and operating methods

must be followed to ensure your system's maximum performance and to avoid unnecessary service calls.

Please read this manual carefully.

REGISTRATION

To fill in the Drainvac product registration form, go to www.drainvac.com/enregistrement

WARNING

Never vacuum liquid or gaseous flammable materials with your system.

Never vacuum ashes with your system.

Drainvac International 2006 Inc. disclaims any responsibility should you infringe upon these guidelines.

THE UNIT WON'T START UP...

SOLUTION :

1) Check the circuit breaker in your electrical panel.

2) Check the unit's circuit fuse/breaker.

3) Check the 24-volt circuit, as follows:

Try to establish electrical contact in a wall inlet with a metal object (for example, a coin).

--> If the unit starts up, the suction hose is defective.

--> If the unit doesn't start up, check to see if the 24-volt wires are properly connected to the unit.

Try to establish an electrical contact between the two terminals of the 24-volt circuit on the unit with a

metal object (for example, a screwdriver).

--> If the unit starts up, a 24-volt wire is either cut or disconnected from one of the wall inlets.

--> If the unit won't start up after these steps, the printed circuit is defective.

THE UNIT WON'T SHUT DOWN...

SOLUTION :

Check the 24-volt circuit as follows:

Disconnect one of the two wires on the unit's 24-volt circuit.

--> If the unit shuts down, the problem could be that two 24-volt wires are touching themselves somewhere

or that the wall inlet is defective.

--> If the unit doesn't shut down, the printed circuit is defective. Unplug the power cord.

If you wish to speak with a customer service representative, contact your supplier or:

Drainvac International inc.

From Monday to Friday, between 9 AM and 4 PM, eastern standard time (UTC-5)

T : 1 800 408-1448 • 450 467-1448

F : 1 877 408-2225 • 450 467-2225

[email protected] • www.drainvac.com

150, Brunet street, Mont-St-Hilaire, Qc, J3G 4S6, Canada

www.youtube.com/drainvacchannel

www.facebook.com/drainvac

TECHNICAL PROBLEMS

TITRE