DRAKE DAD860 Kullanım Kılavuzu - Sayfa 6

Medya Dönüştürücü DRAKE DAD860 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. DRAKE DAD860 15 sayfaları. Digital to analog decoder
Ayrıca DRAKE DAD860 için: Kullanım Kılavuzu (15 sayfalar)

Sayfayı Yazdır

DAD860 Controls and Connections

DAD860

PROGRAM

FRONT PANEL INDICATORS & CONNECTIONS

F1 - LOCK LED - This green LED lights continu-

ously when the DAD860 is locked to the selected

incoming signal. If the lock is lost, such as when no

signal or a noisy signal is present, this LED will flash

on and off continuously

F2 - LINK LED - This amber LED flashes on and off

when the particular DAD860 is selected for pro-

gramming by the DAD860 CONTROLLER or

'DAD860 REMOTE CONTROL SOFTWARE'.

F3 - RS232 PROGRAM - This RS232 connector is

intended to attach to a PC running 'DAD860 RE-

MOTE CONTROL SOFTWARE' for programming

the DAD860 as an alternative to using the DAD860

CONTROLLER module.

LOCK

LINK

RS232

VIDEO OUT

LINK

AUDIO

POWER

RF IN

REAR PANEL CONNECTIONS

R1 - VIDEO OUT - This "F" type connector supplies

the NTSC baseband video output to a modulator or

other suitable device.

R2 - LINK - This receptacle connects to one of the

ten serial cables from the DAD860 CONTROLLER

module for programming the desired parameters

into the DAD860.

R3 - POWER - This receptacle connects to one of

the twelve power cables from the PSM121 power

supply. The cable provides +5V, +12V and GND to

each device to which it is connected.

R4 - RF IN - This "F" type connector attaches to a

CATV (QAM) or off-air (8-VSB) digital TV signal

source.

R5 & R6 - AUDIO L & R - These two RCA Phono

connectors provide left and right stereo audio output

to a modulator or other suitable device.