Bosch SRS2IKW04G Hızlı Referans Kılavuzu

Bulaşık Makinesi Bosch SRS2IKW04G için çevrimiçi göz atın veya pdf Hızlı Referans Kılavuzu indirin. Bosch SRS2IKW04G 2 sayfaları.

Sayfayı Yazdır
en
Before using for the first time, read the operating instructions.
Short and handy...
... everything your dishwasher needs.
How to use your appliance
Load the tableware.
1.
Only clean tableware that is suitable for dish-
washers. Remove large remnants of food from
the tableware. Check that the spray arms can ro-
Overview of water hardness settings
You can find an overview of the water hardness values that can be
selected here.
A table of country-specific units can be found in the instruction
manual.
Hardness
mmol/l
Level
range
Soft
0 - 1.1
0
Medium
1.2 - 2.9
1
Hard
3.0 - 3.7
2
Hard
3.8 - 6.2
3
Adding special salt
To avoid damage to the appliance, only add special
salt to the dispenser for special salt just before the
programme starts.
Unscrew the lid of the dispenser for special salt
1.
and remove.
On initial start-up: Fill the dispenser right up with
2.
water.
Adding rinse aid
Press the catch on the lid
1.
of the dispenser for rinse
aid
and lift
⁠ .
Adding detergent
Add the detergent to the
1.
dry detergent dispenser.
tate freely.
Add detergent.
2.
Switch on the appliance
⁠ .
3.
Setting the water softening sys-
tem
Press
1.
To open the appliance settings,
2.
press
is flashing on the display.
a
LED A
LED B
LED C
Press
3.
water hardness has been set.
0, 1, 2 or 3 LEDs will light up ac-
cordingly.
To save the settings, press
4.
Add the special salt to the
3.
dispenser. The water in the
dispenser is displaced and
forced out. Never add de-
tergent.
Place the lid back on the dispenser and turn to
4.
close.
Add rinse aid up to the
2.
max mark.
2
1
Close the lid of the dispenser for rinse aid.
3.
a The lid clicks into position.
Close the lid of the deter-
2.
50 ml
gent dispenser.
25 ml
15 ml
a The lid clicks into position.
Select the programme.
4.
Start the programme
⁠ .
5.
Remove the tableware at the end of the pro-
6.
gramme.
Programmes
The programme data has been meas-
ured in the laboratory according to
⁠ .
European standard EN 60436.
The consumption figures depend on
for 3 seconds.
the programme and additional func-
tion selected.
repeatedly until the right
The runtime will change if the rinse
aid system is switched off or rinse aid
needs to be added.
Programme
for 3 seconds.
Intensive 70°
Auto 45-65°
Eco 50°
Express 65° - 1h
Machine Care
max
To cancel the programme, press
7.
approx. 4 seconds.
The programme is cancelled and ends after ap-
prox. 1 minute.
1) Duration [h:min]
2) Energy [kWh]
3) Water [l]
1) 2:05 - 2:15
2) 1,150 - 1,250
3) 10,5 - 13,0
1) 1:35 - 2:40
2) 0,750 - 1,200
3) 7,0 - 14,5
1) 3:35
2) 0,780
3) 9,5
1) 1:00
2) 1,070
3) 9,5
1) 2:10
2) 1,150
3) 15,2
for