Bosch SRV53C03UC-30 Kurulum Talimatları Kılavuzu - Sayfa 6

Bulaşık Makinesi Bosch SRV53C03UC-30 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Bosch SRV53C03UC-30 15 sayfaları. 18-inch models

Sayfayı Yazdır

juncLio_ box and

hree prong

plu

are included

Figure

(51mm - 76mm).

3/8"-

1/2"

(lOmm - 13mm)

Figure 5

Remove included

cord set with

3-prong plug and

replace with

household or field

wiring

Replace

appropriate strain

relief

Figure 6

Avoid Electrical Shock Hazard

To avoid possible injury or property damage, care

should be exercised when the dishwasher

installed or removed to reduce the likelihood

damage to the power cord.

Electrical Preparation

Electrical Connection

The dishwasher

electrical suppIy junction box and

dedicated receptacle must be mounted in an accessible

cabinet adjacent to the dishwasher

(do not mount the

junction box or receptacle behind the dishwasher). You will

need a 4I/4'' x 2" (108 x 51 mm) opening throught the

cabinet in order to pass the junction box through (see

Figure 4). tfthe opening is made through wood, sand it

smooth_ If the opening is made through metal, use the

included protective grommet or other approved method to

protect wiring from damage. Use the four screws included

(or appropriate fastener) in the parts bag to secureIy

mount the junction box so that it can be easily accessed

(see Figure 4).The electrical supply can be connected in

...... -"

two ways:

Method A -Three-prong

plug and receptacle

Use the included three-prong

plug and junction box to

connect to a dedicated household receptacle. Make sure

the household receptacle meets the electrical suppIy

requirements as well as national and local codes (see

Figu re 4).

Method B - Permanent connection

to household or

field wiring

Remove the included cord set with three-prong plug and

use the supplied junction box to connect directly to the

household or field wiring. Make sure the househoId or field

wiring meets the above electrical supply requirements as

well as national and local codes (see Figure 6).

To permanently

connect to household

or field wiring:

1. Remove the dishwasher

electrical supply junction box

cover and disconnect

the supplied cord set with three-

prong plug from the terminal block by loosening the

corresponding

screws (see Figure 6).

2. Replace the included outgoing strain relief with one

suitable for the household or field electrical supply

wiring,

3, Remove 2" to 3" (51 - 76ram) of the outer casing of the

household or field supply wiring as shown in Figure 5.

Remove 3/8" to 1/2" (10 - 13mm) of the insulation from

each wire as shown in Figure 5.

4, Insert the ground leg of the household or field wiring to

the ground connection

"€" of the terminal block and

securely tigt_ten the terminal block screw (see

Figure 6).

5. Insert the neutral leg of the household or field wiring to

the "N" connection

of the terminal block and securely

tighten the terminal block screw (see Figure 6}.

6. Insert the line leg of the household or field wiring to the

"L_' c onnection

of the terminal block and securely

tighten the terminal block screw (see Figure 6).

7. Check all electrical connections

to make sure they are

secure and then attach the junction box cover with the

4 screws.