Dramm Autofog MLVH-10A Kullanıcı El Kitabı - Sayfa 3
Boya Püskürtücü Dramm Autofog MLVH-10A için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dramm Autofog MLVH-10A 20 sayfaları.
Sayfayı Yazdır
The Dramm Mini Autofog MLVH-10A sprays dangerous toxic chemicals. Please read and
understand the following safety precautions before operating your Autofog. Failure to follow these
instructions may result in serious injury or death.
• The Dramm Autofog MLVH-10A is a low-volume
application machine that applies Hazardous
Chemicals in concentrated solutions. Care
and Logic must be adhered to. The solution
particle size is very small (0.5 microns to 10.0
microns). Beware of inhalation.
• Follow EPA Guidleines for application of
chemicals.
• Wear Protective Clothing, gas mask, hood
gloves and boots when mixing chemicals, pouring
chemicals into the tank and when applying
chemicals.
• Ensure area to be treated is securely
closed - with no vents open.
• Ensure That No humans or Pets Are In
The Area To Be Treated - death from
chemicals could occur!
• After the machine has been turned on, chemical
application begins. Exit the area immediately.
Secure or lock the enclosure. Post "Do Not
Enter" hazard signs. The Deadly Chemical
Vapor Will Not be Visible! It is your
responsibility to ensure no one can enter the
enclosure for at least 6 hours after the machine has
stopped applying chemical.
• Before Re-Entry, Air Must Be Changed
By Venting. Follow all EPA Guidelines for re-
entry periods.
WARNING
•Do Not Use This Machine In An
Enclosure Where Vapors Can Enter
Any Type Of Air Vents. Care should be
taken to ensure vapors can not reach buildings or
homes in close proximity to the enclosure being
treated.
• After Use, Double Rinse The Chemical
Tank and dispose of rinse water according to EPA
Guidelines. Clean the nozzle and suction line
thoroughly. Store the unit in a safe location away
from children and unauthorized personnel.
• Mix Only The Amount of Chemical
Which Will Be Used to treat the area.
Never - Keep - Store - Or Hold Over
Unused Chemical Solution.
• Your machine is labeled 110 volt - single phase, 220
volt - single phase or 220 volt - 3 phase. Be Sure
To Connect Your Machine To The
Correct Voltage Receptacle. Contact
your electrician for accurate voltage/phase
readings if necessary.
• Exercise Accepted Saftey Procedures
when using electricity.
Dramm Autofog MLVH-10A Manual
5