Dramm HYDRAG-ST100 Kullanıcı El Kitabı - Sayfa 5

Boya Püskürtücü Dramm HYDRAG-ST100 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dramm HYDRAG-ST100 20 sayfaları.

Sayfayı Yazdır

1. Hydra Spraytrax Cart Parts and Assembly Diagram

The Dramm Hydra SprayTrax™ is a hydraulic sprayer that offers a variety of flow rates with

a variety of pressures to allow for maximum flexibility. The Hydra can apply all formulations

of chemicals including insecticides, fungicides, Insect growth regulators, plant growth

regulators, and disinfectants. The Hydra can output all formulations without damage or

corrosion to the pump.

The Dramm Hydra SprayTrax includes either a 1.5 HP electric motor or a 5.5 HP Honda

gasoline motor and a

close-coupled pump capable of 4gpm electric or 8 gpm gas and 550psi, 50 or 100 gallon

tank, maneuverable SprayTrax™ cart with self-tracking axle design, a convex reel with a

separate lock and variable drag system, 250 feet of high pressure spray hose, and a

variable pattern trigger spray gun.

Your Spraytrax comes to you ready to spray. After removing the sprayer from the crate, check

the tank for any additional parts and accessories. Connect the spray gun to the hose using

the quick disconnect. Your machine is now ready for use.

START UP

1. Either switch on the electric motor or Pull-

start the Honda motor by setting the motor

speed to fast & engaging the choke.

more on motor operation see the motor manual

pg 15.

2. Fill the sprayer to the desired level. Do Not

operate the sprayer empty for more than a

few seconds. The water acts as a coolant

and lubricant for the pump and damage

may occur.

3. Start the sprayer with the pressure control

knob in the START position. (A). Do Not

attempt to start the sprayer under pressure

as this will stall the motor and cause an

overload condition.

4. After starting the sprayer allow it to run with

the pressure control knob in the start

position. This will remove any air from the

system, which can harm the pump.

5. Engine speed should not exceed 3,500

RPM. Maximum speed should be set using

the adjusting screw located directly above

the throttle lever of engine.

Hydra SprayTrax Manual

Introduction

Assembly & Preparation

for

NOTE

• Always start and shutdown your sprayer

with the pressure regulator in the ST RT

(priming) position.

• Keep inlet filter clean.

• Always rinse the tank and flush the pump

with clean water after each use.