Draper Access XL Talimatlar Kılavuzu - Sayfa 4

Projeksiyon Perdesi Draper Access XL için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Draper Access XL 8 sayfaları. Draper access xl electric projection screen
Ayrıca Draper Access XL için: Kurulum ve Kullanım Talimatları (5 sayfalar), Kurulum ve Kullanım Talimatları (5 sayfalar)

Sayfayı Yazdır

Access XL E and V 220V

Section 3 - Bottom Access XL Panel Installation/Removal

Bottom Access Panel Door

CAUTION: Beware of pinch points at ends of closure

CAUTION: The following requires two people to perform safely.

1. Press up on access panel and pull toward the front of the

screen housing to disengage hinges and remove access panel.

Access

Remove Screws

Panel Door:

Pivot on Hinges.

from both ends

of Housing.

Section 4 - Motorized Roller/Fabric Installation

1. Remove bottom access panel

2. Back out the two set screws in bracket until they are flush

with top side of bracket

(See Fig 5)

3. To engage motor end bracket flange

, rotate bracket approximately 45°

the top of the screen housing)

counterclockwise to allow top surface

of motor bracket to rest flat against top inside housing.

4. Rotate bracket clockwise until it engages in channel.

5. Engage idler end bracket in same manner as motor end bracket

and slide toward opposite end of screen housing.

Caution: Step 6 requires two people to perform safely.

6. Locate retaining clips attached to instruction sheet.

Lift roller/fabric assembly into screen housing and engage motor

head completely into motor bracket, making sure limit switch

adjusting knobs are visible from bottom of screen housing

Please Note: If snap ring is provided, make sure it engages with

motor. If retaining clip is provided instead, install to lock motor

end in place.

7. Support idler end of roller and slide mounting bracket toward

roller. Insert roller pin into nylon bushing on idler bracket

8. Roller idler pin goes through idler bracket. Reinstall washer and

retaining clip.

Caution: Failure to replace washer and retaining clip could result in separation of roller from brackets.

9. Center roller/fabric assembly by sliding mounting brackets left or right.

10. Securely tighten set screws on roller mounting brackets.

11. Connect electrical plug from motor to mating socket on junction box.

12. Attach door support brackets.

13. Reinstall bottom access panel as previously described.

Bottom ﬂange of

Access housing

Figure 4

Removing Access Panel

(See Section 3)

(above the two channels in

(Fig. 7)

(Fig. 6)

Bottom access panel secures to the screen housing

with two screws

(one on each end)

position by engagement brackets with ball detents that

snap into case support brackets

Figure 3

Access case as seen from below

2. To Remove/Install support brackets:

(

Roller and Fabric standardly ship already attached in place for new unit shipments.)

IDLER END OF CASE

BOTTOM VIEW

SIDE VIEW

Idler End

Mounting

Figure 6

Bracket

Idler End

Retaining

Clip

, and held in the closed

(Fig. 3)

Figure 5

MOTOR END OF CASE

SIDE VIEW

Motor End

Mounting

Bracket

page 4 of 8

Access Panel

Support Bracket

Attaching Brackets:

Insert pin in top

slot and push up.

Rotate bracket

clockwise to lock

bracket in place.

Engagement Bracket

With Ball Detent:

will snap into Access

Panel Support Bracket.

BOTTOM VIEW

Set Screws

Motor End

Retaining Clip

Figure 7