Draper Acumen E Kurulum ve Çalıştırma Talimatları - Sayfa 6

Projeksiyon Perdesi Draper Acumen E için çevrimiçi göz atın veya pdf Kurulum ve Çalıştırma Talimatları indirin. Draper Acumen E 12 sayfaları. Electric projection screen 220v
Ayrıca Draper Acumen E için: Talimatlar Kurulum ve Çalıştırma (12 sayfalar)

Sayfayı Yazdır
Draper Acumen E Kurulum ve Çalıştırma Talimatları
Acumen
E & V - 220V
™

Section 6 - Limit Adjustments

Figure 9
Please Note: Screen limits are
factory set. Instructions below
for minor adjustments only.
Please check with Draper prior
to resetting screen limits.
CAUTION:
- Be sure all switches are in "off"
position before adjusting limit
switches.
- Be prepared to shut off manually
while testing.
Figure 10
Motor
End
d i e
A u
S i d
Standard Roll
White Socket—Down
Yellow Socket—Up
DOWN Limit
DOWN Limit (I)
+
Clockwise
I
Clockwise decreases
decreases
down travel.
down travel.
UP Limit (II)
+
I
UP Limit
Counterclockwise
Counterclockwise
increases up travel.
increases up travel.
- Screen may be damaged by
lowering it too far and
exposing roller.
- Motor must be installed so that
limit switches are pointed down.
Motor
End
e
n c
c k
B a
e
d e
S i
Reverse Roll
White Socket—Down
Yellow Socket—Up
Section 6.1 - Standard Motors
:
(I)
Section 6.1.1 - "Down" Limit Adjustment
To Reduce Screen Drop:
1. Raise screen surface approximately 1'
and turn off.
2. Turn DOWN
3. Test by lowering screen. Repeat steps 1 & 2 until desired position is
reached.
:
To Increase Screen Drop:
(II)
1. Lower screen to down limit.
2. With down switch on, turn DOWN
(3 screw turns = 1/2 roller revolution)
3. Test by raising screen approximately 1'
down limit.
4. Repeat steps 2 and 3 until desired position reached.
Section 6.1.2 - "Up" Limit Adjustment
If Screen Raises Too High:
1. Lower screen surface approx. 1'
2. Turn UP
limit screw clockwise
(II)
Motor
3. Test by advancing screen up.
End
4. Repeat steps 1 through 3 until desired position is reached.
If Screen Needs to Raise Higher:
n c
d i e
1. Lower screen surface approx. 1'
e
A u
S i d
2. With UP switch on, turn UP
(3 screw turns = 1/2 roller revolution)
3. Repeat steps 1 and 2 until desired position is reached.
CAUTION: DO NOT allow dowel to wrap over roller when operating screen!
This could damage screen.
Waterfall Roll
White Socket—Up
Yellow Socket—Down
(Fig. 10)
(requires 5/32" (4 mm) hex key wrench)
above desired setting
(30 cm)
limit screw clockwise
(I)
(3 screw turns = 1/2 roller revolution)
limit screw counterclockwise
(I)
to increase drop.
(30 cm)
below desired setting and turn off.
(30 cm)
(3 screw turns = 1/2 roller revolution).
e
below desired setting and turn off.
(30 cm)
limit screw counterclockwise
(II)
.
page 6 of 12
.
then down to new