Bosch Programme Table Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 21

Sayfayı Yazdır

Bosch Programme Table Kurulum ve Kullanım Talimatları Kılavuzu

Programme terminated

unexpectedly.

Spinning during drying

Drying result not

satisfactory.

The fabric softener is not

completely flushed in or too

much water remains in the

compartment i

The laundry is not dried.

No messages on the display

panel.

The door cannot be

opened.

Emergency unlock.

If you cannot correct a fault yourself (switching on/off) or a repair is required:

– Turn the programme selector to Off and unplug the mains plug from the socket.

– Turn off the tap and call the after-sales service → page 22.

The A (Start/Pause) button has been

pressed accidentally.

No fault

The laundry clings to the sides of the

drum after being spun.

Closed tap

Maximum load exceeded.

Drying time selected too short.

Maximum or minimum load not taken

into account → page 28

The fabric softener compartment insert

is not correctly attached or is blocked.

The tap is turned off.

The laundry load is too large.

The drying time is too short.

Power failure.

$ (Rinse stop) is selected.

The programme is running or the door

is locked for safety reasons.

Power failure.

In order to unlock the door mechanically in the event of a power failure, you will

have to:

turn the programme selector to Off and unplug the mains plug from the

socket.

open the base panel and drain out the water → page 18.

pull the emergency release downwards and open the door at the same time.

– Before opening the door, make sure that there is no water or hot

detergent solution in the washer dryer.

Under no circumstances open the door with the emergency release while the

drum is still turning.

Press the button again to restart the

programme.

"Thermo spin", which is for energy-effi-

cient drying, starts after a drying time

of approx. 10 minutes.

Loosen up the laundry by hand; start

the drying programme → page 15.

Turn on the tap.

Reduce the load for the programme

accordingly → page 28.

Select the drying time according to the

load and the type of fabric.

Once the programme has ended:

adjust the load quantity, select a

suitable drying programme and restart.

Clean the fabric softener compartment

insert and fit it correctly in the

compartment i → page 17.

Turn on the tap.

Reduce the amount of laundry.

Select a suitable drying time.

The programme continues when power

is restored. If you wish to remove the

laundry during a power cut, you must

first drain out the water → page 18.

Check whether:

– the plug is plugged into the socket

correctly.

– the circuit breaker (fuse) has

tripped; if it has, call the after-sales

service → page 22.

Select the programme

Spin and press A (Start/Pause).

Wait until

appears on the

display panel.

Unlock the door mechanically.

[+ B

Drain +